Drive belt and variator replacement on a 150cc GY6 Chinese scooter
Автокөліктер мен көлік құралдары
The drive belt and variator in your Chinese scooter can last up to 5,000 miles.
Torque specifications:
Clutch nut: 36 ft-lb or 49 Nm
Variator nut: 36 ft-lb or 49 Nm
Transmission belt cover bolts: 7.3 ft-lb or 10 Nm
Parts:
Variator kit
www.partsforscooters.com/164-...
Belt size: 835 20 30
www.partsforscooters.com/106-...
Tools:
Rolling wrench CVT holder
www.rollingwrenchdenver.com/c...
0:00 intro
0:15 remove CVT cover
0:43 inspecting the belt
1:32 remove drive face and variator
2:15 inspect variator
3:43 remove kickstart gears
4:33 inspect clutch
6:02 measure the belt
6:58 install clutch
8:04 install variator
9:28 common belt sizes
9:42 install the belt
10:18 how the CVT works
11:16 install CVT cover
12:17 conclusion
Пікірлер: 13
Without doubt the best GY6 maintenance vids I've seen. Thank you so much!
Very underrated channel. Well done sir
Thank you. The variator locking tool can be found for less for those who have less to spend.
4:26 yeah i was removing kickstart mechanism and forgoted to this little bushing and it flyed out thanks god nothing happend
I have a question if you need to replace the clutch output shaft how do you put a bearing on the new one
I have a Ryobi 160 lb torque impact wrench but it will not take off that bell clutch bolt no matter what I do. I also have a 250lb ft. torque breaker bar that also can't seem to remove the bolt. Idk why I can't just use a screwdriver to hold the Bell clutch in place and break the bolt using the torque wrench or impact wrench.
What screwdriver you using or recommend?
What would you recommend for a quicker take off lighter weights or heavier
@LabCoatPaul
Жыл бұрын
lighter weight rollers will keep the engine at higher rpm and give you better acceleration
Why does my belt keep breaking on my 150 cc Chinese scooter. ??
@dendys04
Жыл бұрын
the rear half pulley is broken buy a new one and replace it
How many miles was this
@LabCoatPaul
Жыл бұрын
8,000 miles