DIY Knife from Tablesaw Blade | Heat Treat WITHOUT a Forge
Тәжірибелік нұсқаулар және стиль
I recently came across the left over saw blade I used to make the irons for my homemade finger planes. (link below) I decided to use it to make a custom knife. After sketching out the rough shape, I used a cutoff wheel to cut it out. I shaped the blade on my homemade belt grinder then heat treated the steel using a MAP gas torch. Some black walnut handles and brass mosaic pins finished out the knife. This knife sharpened up awesome and looks great. This was a super fun project. Let me know what you think of the results.
TS Prof Kadet Nero Video - • Testing the TSPROF Kad...
** Affiliate (Commissions Earned) Links to Products Used **
4 1/2" Cutoff Discs - amzn.to/4dqQT5y
4 1/2" Angle Grinder - amzn.to/44yAAPV
MAP Gas torch head - amzn.to/3UGH38a
MAP Gas bottles - amzn.to/3JIX6ft
Mirka 320 grit PSA Sandpaper - amzn.to/44pyxxw
JB Weld 5 Minute Epoxy - amzn.to/4a3FZj2
Boiled Linseed Oil - amzn.to/3y316F7
** Visit My Website **
www.homebuiltworkshop.com/
** Check Out My Handmade Guitars **
www.hayleyguitars.com/
** Save 10% and get some awesome CA Glue from Starbond **
bit.ly/2WJmxbL
** Ways To Support HBW **
www.homebuiltworkshop.com/sup...
** My TeeSpring Store **
teespring.com/stores/home-bui...
** Check out my Amazon Shop **
www.amazon.com/shop/homebuilt...
** Join the HBW Built not Bought Facebook Group **
groups/homebuiltworkshop/
** Connect on Social Media **
/ homebuiltshop
/ homebuiltshop
/ homebuiltshop
/ homebuiltshop
** My Mailing Address **
Home Built Workshop LLC
P.O. Box 84
Peyton, CO 80831
Please remember when using tools of any type, there is the potential for injury. You are responsible for your own safety. Make sure you know how to use your tools properly, work at your own risk, be safe, wear your safety gear, and most of all, have fun!
#knifemaking #handmadeknives #homebuiltworkshop
Пікірлер: 11
I bet a saw blade would make good cabinet scrapers
Cool knife!! That is a good use for dead saw blades.
Cool. That turned out nice.
Nice job. Very sharp video
Fun and informative video, Jeff. I have made a couple of knives in the past and this video has made me think about doing another. Thanks for sharing.
Nice looking knife. I’ve not seen that shape before.
Nicely done.
Always accute info... thanks!
@homebuiltshop
29 күн бұрын
Thank You!
If you're ever unsure if your steel is hot enough touch it with a magnet a magnet will not stick If it is hot enough. The heat causes the steel to demagnetize
I save all kinds of stuff like old saw blades with intentions of doing things like this but I never do.