Genius

tip on bubble noise block off the front out let on the filter and drill 7 or 8 holes on top and you will have less noise i have done it to my one

A cheap way to secure things in a fish tank w/out suction cups is to scratch up the plastic & super glue on rectangular bar magnets. You can stack them if needed.

Hi Foisy, fantastic videos, can't wait for more. I have a question, what do you feed you l333 albino plecos?

@FoisyAquatics

2 жыл бұрын

Thanks! I feed some Hikari carnivore, Ebo Mussel, New Life Spectrum Thera A, and Plecoceramics tablets. Also add an occasional Indian almond leave.

Look on the bright side with this expensive build, if this video gets a million views it will have paid for the lot haha...I do like the look of 5 of those tumbling away though, very relaxing!

@FoisyAquatics

Жыл бұрын

My hope exactly lol!

Diy moving bed filter does work well?

This is a fantastic video. Thanks for posting! Only question I have is do you think you need 6 of these in 1 tank? Would definitely help with cost.

@derekfarealz

2 жыл бұрын

also wondered why they were all in one tank 🤔

@FoisyAquatics

2 жыл бұрын

That's the beauty of this, it can be scaled down or up based on the needs of the builder. I just started with 5 as I'd rather have too much as opposed to too little. I always have a difficult time gauging how much bio filtration is enough so I often go the route of overkill!

@derekfarealz

2 жыл бұрын

@@FoisyAquatics are you going to put that many in each tank?

@FoisyAquatics

2 жыл бұрын

Just in the one fry tank

Does it ever scare the fry?

Great video! Do you sell your fish to stores still? Or have you found other ways to sell them?

@FoisyAquatics

2 жыл бұрын

I do, though only when I have a large surplus of fish which doesn't happen often. I primarily sell on Band and via a monthly email list

@firefallgaming172

2 жыл бұрын

​@@FoisyAquatics Sweet! Good for you man!

A migo ese filtro mantiene el agua cristalina .

Are you going back to lasers? It was going pretty well

@FoisyAquatics

2 жыл бұрын

I wish, but it has been tough to even run one channel with all the other things going on in life lately :(

@PlasmaticZero

2 жыл бұрын

@@FoisyAquatics It’s alright

En ese modelo tendrá para eskimer

does plastic bad for benefit bacteria ?

@FoisyAquatics

Жыл бұрын

Not that I'm aware of!

@TriHard7c

Жыл бұрын

@KassCeeBee doesnt water flow through it will rinse the k1 itself ?

@TriHard7c

Жыл бұрын

@KassCeeBee can it hold aerobic bacteria ?

put your sucking cups in boiling water for a few minuts and they will be like new

Looks nice, but... You can tell by the water surface. There is almost no water flow through the filters. That is the problem with in-tank MB filters. Seems like a waste of time and money. Better to spend money on particulate filtration, and a fluidized bed.

Couldn't you have saved yourself alot of time and money, simply sourcing plastic screws to attach the mag clips instead of the elaborate fixing? I believe those mag clips come with different screw in clips, all you need to do is fit a length of plastic screw which fits in place of the clip end then fix it inside the moving bed suction hole, gluing in place?

Don't babies get sucked up through it

@FoisyAquatics

Жыл бұрын

Tiny fry can get inside unfortunately