If you want the fog lights to stay on with high beams on then you could use a short wire to jump the fuse for the fog lights to an accessory fuse, this will allow you to use the fog lights while the accessory power is on without any other lights on and with the high beams on as well, had done this with an 07 Scion TC.

@THEAVERAGEGUY1983

Жыл бұрын

Nice!!!!! Thanks for the tip. Im gonna look into that. 😎👊

I love, love, love the fog lights but unfortunately the headlight patter is not very good. I'd definitely adjust them again, they do look too low. Make the right one a bit longer than left too.

@THEAVERAGEGUY1983

2 жыл бұрын

I adjusted them a couple of days right after I made the video and I was blown away. These are the shit and worth the money. I've been. Testing them out in the rain and they have pretty good visibility but they perform excellent in dry weather conditions. 😁👍

@jasoningle43

2 жыл бұрын

@@THEAVERAGEGUY1983 How many people coming toward you flash you because your lights are too bright?? hahaa What lights did you put in the fogs?

@THEAVERAGEGUY1983

2 жыл бұрын

@Jason Ingle the honest answer to your sarcasm is Zero, almost everyone here in Los Angeles has Factory LED Lights in the newer models that are even brighter then mine, or at least facing up higher. When I'm driving behind someone's car my headlights Do NOT exceed the height of the door handles and blind the driver in front of me, the only way that would happen is if their car is lower then factory. Now for your other question For the fog lights they are the same ones as these but in a H11 size. Thanks for watching. 👍😉

I do 30ft full tank or half tank with a person inside then adjust the lights this how I do it hope it can work for u

@THEAVERAGEGUY1983

2 жыл бұрын

Thank you for the advice, I got it set up well and I am very impressed with these!

Nice job Bro, Can we get a stereo SQ update since the speaker should be broken in now? OORAH

@THEAVERAGEGUY1983

3 жыл бұрын

Absolutely! That is going to be next in the channel!

I got the 68w glowtek h13 12,000 lumen hi/low in mine. The only downside is that I had to redirect the lamps almost fully down so I'm not blinding everyone on the road but they literally turn night into day. I really need to get the switch back signals and some leds in the fogs still. The problem I'm having with my running ambers is they no longer stay on in any switch selection. The signals work but the steady on part won't stay on and the dealership can't figure out why. 😕

@THEAVERAGEGUY1983

3 жыл бұрын

Nice on the 68 watt LEDs for the Headlights! I have try adjusting mine more up tonight lol! They are too low to the ground . The switchbacks I have from GTR lighting are nice and have been working out so far. They do get some hyperflashing after 8 minutes of them being on at a long waiting traffic light stop but go back to normal a minute after you turn them back off. I'm guessing it's due to heat. As for your amber lights, 1. Have you checked to make sure the second light output of your bulbs are not blown? There are 3 lights on each bulb. One that stays on on a lower voltage and the other that turns on bright for your turn signals. The other option would be to go into your dashboard settings and scroll down to my vehicle and then under that category you should see the option for having Daytime Running Lights On or Off. You would just need to select them to ON and that should work. If not.... then there could be a short somewhere. Also remember that the Fog Lights are connected to the same fuse as your turn signal/ Daytime running lights. So if that is burned out, it can affect that light issue. Hope this helps a bit.

@Onyx_Games

3 жыл бұрын

@@THEAVERAGEGUY1983 the bulbs for my turn signals and the parking lights are all brand new. The fog lamps work just fine. The turn signals work flawlessly. The only thing that doesn't work are the led side running ambers and the 4 front steady on. I haven't been able to find a single tech that can figure it out. I don't think that I have a day time running light option for my flex. I have gone through forscan and made some changes recently without any results, including turning that option on I'm forscan through my laptop. Even turned options on in the car that the car doesn't have hahaha. Turned those useless features off though since the car doesn't have the equipment but it was pretty funny to see fault errors on the dash for equipment my car doesn't have lol. It really bothers me that the steady on ambers won't turn on at all so I've put the idea of switchbacks on hold until that issue can be resolved. I've been to broke to get the fog lamps. But I think I'm going to also go with the glowtek brand for those as well because of the extreme amount of light output they have.

@THEAVERAGEGUY1983

3 жыл бұрын

@@Onyx_Games oooooooooooh!!!!!!! Does your front headlight have 3 little Amber color LEDs on the headlight assembly corners that's right next to the front fenders? If so, those are NOT replaceable, if they burn out ford usually recommends replacing the whole headlight assembly. Those lights are like the LED top tail light that sits right at the tail gate of the flex. It's like that for any 2013 to 2019 ford flex model that has that. Usually below those led lights it might even have the FLEX letters engraved in black. That's a 3 LED mini circuit board with resistors on the board. It would be too complicated to take the head light apart and try to test the Resistors. It would also require Soldering so if by any chance the car has an extended warranty, it might cover the replacement.

@THEAVERAGEGUY1983

3 жыл бұрын

@@Onyx_Games but you also mentioned the front 4 turn signal lights that work as turns signals with no issues but just to remain on after the turn signal stops right?

@THEAVERAGEGUY1983

3 жыл бұрын

Another thing that just came to my mind is the BCM which is located right underneath the Center Console, those lights your talking about are connected to that which happens to use a Relay that's inside that box. Not sure if the dealership checked that for you to see if it had a faulty code.

Love how the person in front of you drove that dark road with no lights, the whole time 🙄 What color temp did you pick up? I got the 6500 and the visibility is not great

@THEAVERAGEGUY1983

2 жыл бұрын

Yeah we get that alot here and I don't under how people can drive with their Headlights off at night. The color I went with is 6000k. I believe the Accu V2s are only offered in 6000k as well. They have been performing great for me after re adjusting the Headlights again a little bit higher. The only thing I did notice is that when it rains the lights struggle a little to brighten up the road when the street is wet but it's only in areas where the street painted roads are kind of faded out or old. So if I go on a nice re paved street where the white and yellow paint was also re done and sure enough it was very well visible.

What turn signal switchbacks did you decide to go with?

@hottestindasouff5112

2 жыл бұрын

Neeeevermind. Just saw the vid

@THEAVERAGEGUY1983

2 жыл бұрын

@@hottestindasouff5112 its all good. I do have the link in the description. If you get your self a pair, go for the Non CK version of the switchbacks. They can still do hyper flashing if they are on for too long, that seems to happen to me alot specially when I go to work. There is this one street that takes like 10 minutes for the Left Turn Green light to finally light up lol! So just keep that in mind. Once the turn signal part of the light cools down internally, it starts to flash at a normal speed.

@hottestindasouff5112

2 жыл бұрын

10 mim??? Dayum!!! lol. Preciate-cha brotha.

@THEAVERAGEGUY1983

2 жыл бұрын

@@hottestindasouff5112 😁👊

What type of bulbs and brand do you have for fog lights

@THEAVERAGEGUY1983

2 жыл бұрын

Hi! I have the Same DDM Saber Pro X 55 Watt Accu/V2 LED Bulbs but in a H11 size. They work great and are very bright but....... very pricey, I paid about $177.00 with Taxes and Shipping Included in the price. But they definitely are very bright. I also did a review on some H11 LED Fog Lights for a Company Called Auxito which I have a video on that one. Those have Half the Brightness power that the DDM Tuning ones do and they are only $37.99. That's a HUGE price difference for Half the Light Output of the Saber Pro X LED Bulbs. I have a link in the description on that video that can save you 12% off your order. Since I didn't Colaborate with DDM, and you buy some for your car, you will have to pay full price for them unless they are having a labor day sale too. Hope this helps, if you have anymore questions about what I have installed in the car please feel free to ask.

@MR70726

2 жыл бұрын

@@THEAVERAGEGUY1983 thanks I'll make sure to watch ur other videos

those LEDs dont have the side coverage like HIDs do... only front.

@THEAVERAGEGUY1983

2 жыл бұрын

Do you own these DDM Tuning LED Headlights Too? What car are you using them on? because with Reflector Headlight lense These LEDS have excellent Side coverage and even better front view coverage the output also depends on the kind of car you drive, how large are your Headlights as well as conditionof the Headlights like are they all faded and yellow looking? However when it comes to Projection Headlight lense I don't recommend them as they need even more output to be able to give you a great direct light output plus I would assume that a Front LED light would also need to be facing the front in order for it to work well. Now, For Projection Fog light lense Yes, I do recommend them as with fog lights the important part is pavement lighting and these do the job very well.. As for side coverage I am NOT sure what you are talking about. The leds on these bulbs are actually on the left and the right, they don't light up all around like HID bulbs do but they are very bright for Reflector Headlights. Thanks for watching.

U gotta change out that dealer plate frame bro lol unless montebello ford giving you $$ 👀😂

@THEAVERAGEGUY1983

2 жыл бұрын

Hehehehe, already did. I got a Black Metal Ford Frame that says FLEX on it in chrome letters and the blue Ford logo at the bottom, I feel like it's a little overkill having the word flex everywhere in the car but I have been getting asked lately what kind of car is it? So I figured this would save me some explanation time. 😅

They are bright, but the beam pattern sucks because these should be used in a projector housing.

@THEAVERAGEGUY1983

2 жыл бұрын

Maybe so but after I adjusted them again now they work awesome. 😁👍