I watch a video and learn something new everyday!!!!

Very cool. I don’t have a CNC yet and still working overseas in the sandbox, retiring next year. Want to build my own Strat but left hand version. Maybe that’s available as an option in the software or in the pdf download you mentioned. One thing I’d like to do is use a maple binding on the top as post off the round off. Might be something in the software for that. Thanks for the videos.

@JayceAllanGuitar

2 ай бұрын

making left handed is super easy, just select everything and mirror it horizontal. I haven't done a binding channel yet, but I'm guessing that would be pretty easy too.

when you were setting the distance of your drill holes, is there a reason you couldn't just mirror the first one about the job center. then you wouldn't have to do all the calculations. or did I miss something? Thanks Greg

@JayceAllanGuitar

3 ай бұрын

You're absolutely correct and it'd be more accurate. At the time I didn't know about that feature. Good observation.

@gregraso557

3 ай бұрын

@@JayceAllanGuitar Jayce, I have another observation, and I don't mean any of this as criticism, as I don't know everything and I'm always learning from others. I appreciate the videos and I thank you for posting them. When you're in material setup while setting up your 3D roughing. I've found that it's a good idea to always set the gap above model to at least .01. It doesn't matter in the case of the guitar body because you're only roughing and finishing the edge, and there is not much detail in your model. However, if your 3D model goes across the whole surface, and it is detailed, and if there are any variations in the surface ( like a small low spot), your bit will not touch and you may miss the detail. how's that for a run on sentence? Anyway just trying to pass a tip on. Good luck and keep the videos coming.

@JayceAllanGuitar

3 ай бұрын

@@gregraso557 I'll give that a try, thanks. I appreciate useful feedback.

I don’t have the toggle top/bottom option on aspire. Any other ways to edit the back of the guitar?

@JayceAllanGuitar

3 ай бұрын

I would just make two separate files. One for top one for back. Make sure material is the exact same dimensions then center the body both X and Y.

@sirjeffthethird269

3 ай бұрын

@@JayceAllanGuitar ok, thank you!!!

@user-en5ov5rj2m

2 ай бұрын

Did you set it to two sided in the job setup? It's not there if you leave it at one sided.

@JayceAllanGuitar

2 ай бұрын

Yes, definitely set up your job as 2 sided.