I used to work for Chesapeake Energy. Beware if you get hurt while working here. I did and had to sue the company's insurance company. And Chesapeake has such influence over workman's compensation laws. I didn't want to do this but had no choice after I was injured because they didn't take care of me. Even after I had my surgeries at least I can work. And the money I received after the injury was pathetic.

thank you

Cool

It its possible to operate this tecnology in a heavy oil wells?? Its possible to convert one vertical oil well into a horizontal well??

What happens to all the fluid when it's removed to put the plug in? Wouldn't the natural gas mix into the water as soon as it's fractured? So when the water comes up, wouldn't gas and oil come up with it? I get that the fissures remain open and can flow freely into the well bore once the plugs are all removed, but what confuses me is what happens to all the oil gas in between each of these steps. It's not like the oil and gas are going to sit there and say "okay we'll wait until all the perforations are fractured and plugs removed before we start flowing to the well". It seems like some oil and gas has to be lost in the process. Please help clear this up for me! Thanks.

Excellent presentation keep it up

Bonjour monsieur Esnault

Hello Mr. Esnault

@tralalaralaetkrony

9 жыл бұрын

***** oh you here mr paopao, it's a pleasure to see you

@PaozBeats

9 жыл бұрын

yea it's me ! It's amazing !!

@PaozBeats

9 жыл бұрын

Lucas Valois Thanks Lucas your a good guy !

Genius!

How do they actually turn the string from vertical to horzontal?

@dippyanddakota

10 жыл бұрын

Bent sub. Down hole motor. If they stop rotating the pipe and still pump thru the motor the hole will turn in the direction of the bent sub. When they want to go straight, they rotate the entire string.

@thedude4795

10 жыл бұрын

what is a bent sub?

@dippyanddakota

10 жыл бұрын

Izio Shaba To drill with a mud motor rotating the bit downhole without rotating the drillstring from the surface. This operation is conducted when the bottomhole assembly has been fitted with a bent sub or a bent housing mud motor, or both, for directional drilling. Sliding is the predominant method to build and control or correct hole angle in modern directional drilling operations. Directional drilling is conceptually simple: Point the bit in the desired direction. This pointing is accomplished through the bent sub, which has a small angle offset from the axis of the drillstring, and a measurement device to determine the direction of offset. Without turning the drillstring, the bit is rotated with a mud motor, and drills in the direction it points. With steerable motors, when the desired wellbore direction is attained, the entire drillstring is rotated and drills straight rather than at an angle. By controlling the amount of hole drilled in the sliding versus the rotating mode, the wellbore trajectory can be controlled precisely.

good video

Sounds pretty good to me.

good

I have share in the company planning to boost it up

@georgebrudi4907

4 жыл бұрын

Anthony raymond Luna I’m sorry to hear that

@MKxpl

4 жыл бұрын

sucks to be you

😂😂😂

My EX has one of these, she got it after we broke up.