Nice job, noth'n fancy but she will cut good. I rarely file the rakers, only if my saw stops biting which rarely I'd an issue, I prefer a taller raker for better control of the cut. Good job sir..

I was running this saw for about 2 hours at about a 30-50% duty cycle kzread.infoUgkxfQm1wmg0ItKDLavxj1nXtQY9HP7EF504 and it did a great job. I used the lever for the built in sharpener to clear chip buildup out more than to actually sharpen the chain. It managed to cut some hardwood stumps much larger than it's size without bothering the neighbors with hours of 2 stroke noise.

I have just bought a dremel and there kit love it first time I ever sharpen a chain just left a little bur it is semi chisel so put a pointed stone in took the bur off I can't wait for it go blunt again 😂😂

Nixe video . Gotta love a fresh file . Takes minimal time to sharpen a chain

@jarrodskeete52

Жыл бұрын

Yes sir..... Love a fresh file.... Hardly any pressure and u can watch the steel dissappear!

Коротко, просто, понятно. Отлично!

new subscriber👍👍👍👍

I like the tooth filing! You did really nice job there but The raker gauge that you are using it will turn your chain to cut crooked and eventually will produce only dust by the middle of the chain and back! Update to a progressive debt gauge for more consistency of tooth bites!

@jarrodskeete52

Жыл бұрын

Thanks! What progressive gauge are you referring to.. Do you have a particular brand?

@kostasfrangos3354

Жыл бұрын

@@jarrodskeete52 there not so many! Huqsvarba makes and also stihl! And west coast! I use stihl cause my Chains are stihl

@josepodasdemadeira

Жыл бұрын

​@@jarrodskeete52 👍💯

Thanks for sharing, congratulations on the video. What brand of lime?

👍👍👍

Sangat menarik

Good👍🏾

Wow

Nice point of view

Great lesson on sharpening chains! I'm the founder of EzzDoo, which makes sharpeners. How do I contact you to ask you questions?😃

Its called sawchain, mr expert.

Testerenin disini bitirdin uc sefer sonra yeni zincir

I had a saw sharpening business for years and NEVER once did I ever have to touch the rakers, it's BULLCRAP

@jarrodskeete52

Жыл бұрын

You can get away with afew light sharpening without touching rakers but you will notice smaller chips each time.... It Will get to a point where the tooth is reduced to same Level or just above the raker where you just produce sawdust and not chips.... Just the physics of it.

@leroyjenkins9519

Жыл бұрын

You are correct, to an extent. How far do you utilize your chain? Once you reach a certain point, it's a must to adjust the depth gauges in order to maintain proper performance at it fullest.

@spencerh2860

Жыл бұрын

In that case I wouldn’t want to use your business