No video

Build Subwoofer Boxes!

Two sealed boxes, plus two 6x9 boxes, for the '61 Chevy pickup! Something to block out all the wind noise, squeaks, rattles, and screaming in the truck.
KZread Audio Library:
"In the Sweet By and By" Zachariah Hickman
"Sweethearts" TrackTribe
"Chunk" Quincas Moreira
Follow the build: www.gwellwood.c...
=====
Turbocharged '61 Chevy Pickup Project Playlist:
Planning: • Planning it Out!!
Brakes: • Fixing the Brakes on m...
Running: • First Start of my 1961...
BONUS - Alive: • BONUS: Alive After 20 ...
Driving: • The First Drive in 20 ...
New Drivetrain: • Picking The Drivetrain
LQ4 Refresh: • Refreshing an LQ4 6.0L...
Frame Mods: • Truck Frame: Shortened...
Suspension & Steering: • Laying Low, Rack & Pin...
Motor Mounts: • A Whole Wack of Stuff ...
Inner Fenders: • Tubbing Inner Fenders ...
Turbo!: • "DIY" (Fabrication-Hea...
Coolers & AC: • Placing all the Cooler...
Cab Rust: • Fixing ALL the Nasty C...
Rusty Doors: • Fixing the Doors!
Bed Shorten: • HOW TO: Shorten a Step...
Panhard! • Fabricating a Panhard ...
Hood Repair: • Fixing The Hood
Rear Fenders: • Fixing Rear Fenders!
Nose: • Fixing The Nose!
Bed Patches: • Fixing the Bed!
Front Fenders: • Fixing Front Fenders!
BONUS - Hood Blasting: • Remove Paint AND Stress!
Cab Blasting: • Blasting the Cab!
Frame Blasting: • Blasting the Frame
Primer!: • Primering the Pickup!
BONUS - Trailer Hitch: • BUILD: A Trailer Hitch!
Gas Tank: • Rear-Mounted Gas Tank!
BONUS - Fully Rollerize a 4L80E: • HOW TO: Fully Rolleriz...
BONUS - Install a Limited Slip Differential: • HOW TO: Install a Limi...
Begin Reassembly: • Reassembling the Truck!
Pre-Paint Prep: • Pre-Paint Prep Prep!
BONUS - Tailgate Logo!: • Put Your Own Logo in Y...
Paint!: • Painting the '61 Chevy...
BONUS - Modernize your Steering Wheel: • Vintage Steering Wheel...
Back Glass: • HOW TO: Install Back G...
Windshield Glass: • HOW NOT TO: Install a ...
Door Glass: • HOW TO: Install Door G...
BONUS - Barrel Engine Cover: • HOW TO: MAKE an LS Eng...
Headlights: • Installing & Wiring Aw...
Turbo Exhaust: • Fabricating Turbo Exhaust
Fixing Door Latches: • Fixing Door Latches
Bumper Brackets: • Making Bumper Brackets
Modern Wipers: • Fitting Modern Wiper Arms
Stainless Fuel Filler: • Fabricating a Fuel Filler
Brake Lines: • Making Brake Lines
Battery Mount: • Frame Mounting the Bat...
Coolers: • Engine & Trans Cooler ...
BONUS!! TEASER!! • '61 Apache Teaser
DBW: • Fabricating a Drive-By...
First Start? • Finally, a REAL "First...
Boring Cummute: • The Boring Commute 3: ...
Cup Holders: • Fabricating a Cup Holder
Buckets: • Modern Seats & Belts F...
Tunes: • Build Subwoofer Boxes!
DAMAGE! • This Air Filter Could ...
Car Show: • Knox Mountain Hillclim...
Tuning: • Hacking a GM Computer ...

Пікірлер: 11

  • @kazzxtrismus
    @kazzxtrismus5 ай бұрын

    your box construction is fine because you got it all together while the glue was very wet....built hundreds over the years and worked the industry back in the 90s....MDF will swell a bit with the glue..we often used drywall or deck screws bondo can be used on box corners for small gaps and hiding screw heads.. MDF is very forgiving until water gets involved...your box is well sealed/coated...but...id even spray the inside. MDF will find water in a desert and swell

  • @goptools
    @goptools5 ай бұрын

    Nice build for the speaker boxes. MDF is a pain to work with. It makes an incredible amount of dust and is much heavier than you would think! I also like the sound to be heard outside the vehicle for 2 reasons. One, because I'm pretty hard of hearing (maybe from having the volume turned up load for many years) and two, so today's kids can hear what good music sounds like! I am not a bit opinionated.

  • @adamschewe7166
    @adamschewe71665 ай бұрын

    Really enjoyed this !

  • @jimdean7335
    @jimdean73355 ай бұрын

    Rock on

  • @paulsmith9341
    @paulsmith93415 ай бұрын

    When i did handyman stuff on the side I'd often get paid in a combination of money and a cardboard box with a bunch of tools, fasteners and cool junk.

  • @Maplecook
    @Maplecook5 ай бұрын

    Fascinating, man. Did my heart good to see that amp again. haha Hard not to wince, watching you grind away with no breathing protection though...

  • @jamesp1586
    @jamesp15864 ай бұрын

    Super nice build. I just found your channel and will be checking out your videos.

  • @tjacksonwoodworker3726
    @tjacksonwoodworker37265 ай бұрын

    try Hooked on a Feeling by Blue Swede.. Another great video

  • @luisbatista1103
    @luisbatista11035 ай бұрын

    Sand it till you can't stand it lol 👍🏼👍🏼👍🏼

  • @luisbatista1103
    @luisbatista11035 ай бұрын

    Where's the music? No Celine Dion c'mon man lol 👍🏼

  • @GregWellwood

    @GregWellwood

    5 ай бұрын

    Royalties, man lol.