Perfect video thank you :)

Danke für Video perfekt

Thanks great video, did mine had to bleed injectors then fired up

Going to try this myself 😮

Where can I find something showing the tightening order for the N47 4 cylinder?

How did you get the injectors to come out so easily? Any advice? I’ve seen people use a slide hammer, but I have the same injectors on my n47 e84 like in this video that have the fuel line on the side instead of the top so there’s no where to screw the hammer into.

Have the injectors washers been changed? did it get old

Did you tell replace injector seals

Great Video but what torque is needed for rocker cover bolts?

@MarkoFQ

11 ай бұрын

10Nm

What is the socket size for rockerarm cover?E10 or E12?

Kya isse dalne se lekage nhi hogi kya

Hi Great video, what torque was the injector clamp set to? Going to need to do this soon.

@Nicrig

6 ай бұрын

ive done mine on 26 Nm all perfect no problems since two years ago

@Nicrig

6 ай бұрын

also recomended if the car has over 100k miles to replace the whole rocker cover not only the gasket

@unclepabs

3 ай бұрын

@@NicrigGood point as the Crankcase ventilation diaphragm (under the disk cover behind the oil filler) can go stiff & increase rocker pressure & cause the gasket to blow again or even worse symptoms! Replacement crankcase diaphragm & cover from Viaco is part V20-3341

Hi, so you only changed the gasket?

how long was it cranked over before it started and did you have to bleed anything

@champagnepapi9428

3 ай бұрын

even 2 minutes, don't be scared just wait

Na ja nicht schlecht aber da ist novh viel zum machen,ware besser neuer Ventildeckel plus injektor reinigen , Dichtung auch wechseln und und also

@RikiJasmin

4 ай бұрын

Neuer Motor einbauen wäre noch besser

È sbagliato farla partire cosi, si rovina la pompa cp4

You are living in Dune?