keep up the good work.

Excellent video. Straight to the point. Would be good to have a link where you get the specialist tools.

@roodlum

2 жыл бұрын

Thanks! The tools are from www.cycleworks.net

stumbled upon your videos and I'm excited to find out you are restively local to me! do you ever rent out any of these specialty tools? i am diving into a 75/5 build and looking to be diving deep into the engine rebuild as well.

Nicely done. I am kinda in the same boat. On my 88 GS, I found slight pitting on the followers and quite a bit of scoring on the oil pump rotors. To judge the damage, I pulled the crank-rod bearings too and same story there. Not bad, but there is visible scoring. How did you get the crank reassembled?

@roodlum

3 жыл бұрын

Thanks. I have a couple other videos showing putting the motor back together with new bearings, including the main bush bearings and conrod bearings, check em out.

Definitely feel smarter watching you work. But honestly these engines are fine as they are for another 50 years with such minuscule wear.

@roodlum

3 жыл бұрын

Thanks. You're right, of course, this motor still had a long healthy life ahead of it if left untouched, but since we're doing some pricey upgrades we thought it best to make sure it was in top condition!

Nice work. How did the crank journals look?

@roodlum

3 жыл бұрын

Thanks. Bearings did their job as everything looked good and measured to spec!