Nice car

What ecu use bro

hi, in your previous video you talked about using an m52 head, im in Australia and have a 94 325 head, is that still considered early?

@iconicars3050

2 жыл бұрын

You have to check what valve train it has. If has smaller diameter valve springs and smaller diameter lifters than you’re good to go. Late m50 heads are the same as M52, same valve train and cam trays. M50 head has an extra hole for temp sensor, m52 does not. Usually a 94 head is built in 93 so its no good. You can always use m54b30 valve train, its also very good and can take 7200rpm. Just swap it over into your m50 head.

Hi, I'm planning to do this same stroker build but boosted, how many psi do you think will hold and how much power will it make with it? This stroker build also applies for boosting? Or there's another kind of build for turbo? Thanks and sorry for the bad English

@iconicars3050

2 жыл бұрын

No idea. This wasn’t intended for boost.

How did you get rid of the ridge in the cylinder bores without going over bore?

@iconicars3050

2 жыл бұрын

There is a special tool for ridge removing. It gets mounted inside the cylinder and cuts.

BONJOUR EST IL IMPORTANT DE METTRE LES RESSORTS DE M3 US EN MEME TEMPS QUE LES ARBRES A CAMES US S52 POUR 7200 RPM,?

@iconicars3050

2 жыл бұрын

You can use M3us S52 springs or S62B50 springs or M42 springs, they are the same, they can all rev to 7200rpm. But make sure you also use lower and upper spring retainers.

How much hp does the m50b30 make?

@iconicars3050

2 жыл бұрын

It all depends what cams you use, exhaust setup and how good your tune is. Mine made 228whp.

And what inyectors

@iconicars3050

Жыл бұрын

21.5lbs pink. From e36 328.