Bleeding the front brake on a 150cc GY6 Chinese scooter
Автокөліктер мен көлік құралдары
In this video, I'll show you how to bleed the brakes on your Chinese scooter. This procedure is the same for most motorcycles too. Make sure to use DOT 3, 4, or 5.1 brake fluid.
Torque specifications:
Brake lever banjo bolt: 19 ft-lb or 26 Nm
0:00 intro
0:06 open reservoir and fill fluid
0:17 brake bleed procedure
1:06 re-install brake lever cap and clean up
1:37 different types of brake fluid
2:23 conclusion
Пікірлер: 6
Just the video I was looing for. Thank you sir!
I appreciate your work. Thank you.
Hi, I bled the brakes on a Lance Havana Classic 200i but I am getting zero resistance on the brake lever. This scooter has a combined brake system. The lever on the left has full resistance and brakes fine. Do you have any suggestions?
All sudden my scooter is harder to start and and it has loss of acceleration power
Now, I have seen some videos unscrewing the area and then pumping the breaks a few times. Please advise.
Er.. Bleeding the break takes about an hour? Seems like it would take 10 minutes! LOL I'll give it a shot later today.