Adjusting the CO on a 16V MK2 Golf GTI

Автокөліктер мен көлік құралдары

The C0 Mixture on your car can have a big effect on not only the emissions but also the car runs and feels. A standard 16v MK2 GTI Golf shoudl be set to 2% CO.
In this video using the Rubber Johnny Guide i have set mine to ROUGHLY 2% (up from 0.7%)
Support me on Patreon / mk2golfstories
Or
Buy me a coffee: www.buymeacoffee.com/mk2golfstoD
Intro Music - ‪@tiorico2299‬ - Somewhere Between
See how the Bosch K-jetronic CIS system works: • Bosch K-jetronic - The...

Пікірлер: 44

  • @LighthouseBaptistChurchAlmere
    @LighthouseBaptistChurchAlmere2 ай бұрын

    Thanks, going to give it a go!

  • @MK2GolfStories

    @MK2GolfStories

    2 ай бұрын

    Nice, good luck

  • @garybocking4541
    @garybocking4541 Жыл бұрын

    This takes me back,The guide was written by your's truly about 20 years ago and modified by Rubjonny oh btw it's not Rubber Jonny it's Rubjonny lol

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    Oh man i've been calling you RubberJonny for ages hahaha I thought it was a funny name lol sorry about that! Also thank you so much, i have found a few of your guides VERY useful. You are an absolute legend

  • @garybocking4541

    @garybocking4541

    Жыл бұрын

    Sorry for any confusion I'm not Rubjonny, !! I'm GVK off the forums, you're right though Rubjonny does write some helpful stuff.

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    Oh sorry I misread your first comment. I thought it was written by rubjonny, I should be thanking you for the guide! It was really helpful and made a massive difference ! So thank you very much.

  • @rubjonny1

    @rubjonny1

    Жыл бұрын

    well rubjonny is short for rubber johnny, used to get called it all the time so went with it lol

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    @@rubjonny1 haha quality :D:D

  • @anesennaidoo5279
    @anesennaidoo5279 Жыл бұрын

    This is amazing.... thank you for the content

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    you are wecome im gad you like it :)

  • @mattie32
    @mattie32 Жыл бұрын

    Is that your Dad with you in the clip..? The conversation between you two in the car when you were driving it on a bit put a smile on my face 😀

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    It is yeah! He’s a funny bugger, he’s in a lot of the videos now, I’m glad to have him helping me with these and have him on camera with me

  • @markbourne8183
    @markbourne818311 ай бұрын

    Thanks for the information was a great help.

  • @MK2GolfStories

    @MK2GolfStories

    11 ай бұрын

    I’m glad to hear that mate :)

  • @olaniyanmichael640
    @olaniyanmichael640 Жыл бұрын

    ❤❤❤😊 I am really excited.

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    Thank you

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    I hope your conversion goes well

  • @mcjdubpower
    @mcjdubpower9 ай бұрын

    Loves me a bit o Kjet

  • @MK2GolfStories

    @MK2GolfStories

    9 ай бұрын

    Ohhhh yeaaaa

  • @markflight8656
    @markflight865612 күн бұрын

    Dude I need your help man no one knows what's up with my mk1 with the 1.8 16v engine. Starts when cold not atall when hot :( any advice will help! I have videos

  • @MK2GolfStories

    @MK2GolfStories

    12 күн бұрын

    @@markflight8656 hi mate Have you tried disconnecting the connection to the WUR (warm up regulator) on the side of the engine (think it controls 5th injector ). You could always try asking Grey Goose on here or Instagram, he knows his shit

  • @zaccharalambous9664
    @zaccharalambous9664 Жыл бұрын

    Hey bud really helpful tutorial only thing is for me it won’t start after removing the breather and wire any ideas

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    Hey man, try it with just the wire out first, how does it do? Maybe try unplugging that while it’s working. If the revs plummet turn the idle screw until it steadies out (make a note of how many turns and in what dir incase you need to undo it)

  • @zaccharalambous9664

    @zaccharalambous9664

    Жыл бұрын

    @@MK2GolfStories hey bud if I unplug the wire whilst running it jsut dies instantly. I think it may be overfuelling only recently picked it up. Very nee to krs so any help is appreciated

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    @@zaccharalambous9664 wind out your idle screw (make a note of how many turns ) and try again

  • @totte1015
    @totte1015 Жыл бұрын

    My emission test got passed, it only measured CO2, and I got the value 1,5 Does that mean 1,5 percent? I do have some backfiring when letting off the throttle So basically I should do this guide and screw the CO screw tiny bit clockwise?

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    i believe so yes, its takes the TINIEST of turns, so be very genetle with it. in teh end mine went to a local garage and they sorted it out properly, a mixbetween the o2 screw , the idle screw and the electronic timing

  • @ttcinemas570
    @ttcinemas570 Жыл бұрын

    is this the same exact way for a 1986 8 valve cis e ?

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    I really couldn’t tell you, I’ve no experience with that engine I’m afraid.

  • @hichemrh5893
    @hichemrh58932 жыл бұрын

    Hello brother I hope that you are doing Well I need an advice from you about mk2 GTD 1.6 year 89 Cause i found one but i never had a diesel car so any word from you it will mean a lot for me Best regards from algeria

  • @MK2GolfStories

    @MK2GolfStories

    2 жыл бұрын

    Hello man! I will try my best to help you; although I am by far no expert! What’s your question? Feel free to ask

  • @hichemrh5893

    @hichemrh5893

    2 жыл бұрын

    @@MK2GolfStories Thanks again for asking M'y question is about the engine and his duration of life problems ect... Thats all.

  • @MK2GolfStories

    @MK2GolfStories

    2 жыл бұрын

    I don’t really know myself, I have only owned one diesel golf and it’s the 1990 GTD. there have been a lot of issues with mine but none so far have been the engine itself. I believe they should be good for over 200,000 miles

  • @hichemrh5893

    @hichemrh5893

    2 жыл бұрын

    @@MK2GolfStories Thanks a lot for sharing the informations and for your time have a Nice day.

  • @deshninaidoo2613
    @deshninaidoo26134 ай бұрын

    I got a golf 2 1.8 carb don't want to start 2:32

  • @MK2GolfStories

    @MK2GolfStories

    4 ай бұрын

    Carbs are an entirely different beast, i have NO experiance woth them, i believe you need to get them set up JUST right though!. check the forums / facebook pages, someone who knows what theyre doing will be able to help

  • @TheZigzagSmoke
    @TheZigzagSmoke Жыл бұрын

    Mine is too high. Just failed emissions 4.5 % .. Just curious what is the red cable that you disconnect?

  • @MK2GolfStories

    @MK2GolfStories

    Жыл бұрын

    The red lead is to the ignition coil

  • @MrStevecrasher

    @MrStevecrasher

    8 ай бұрын

    It is red and black, this powers the Idle Stabiliser Valve/overrun cut of valve ECU in the centre consul and shuts down its operation BUT this is not a necessary part of setting the CO.

  • @MrStevecrasher
    @MrStevecrasher8 ай бұрын

    You don’t block the Air Flow Sensor Input, no point and with the breather hose still attached to the inlet manifold via the bleed hose you are still pulling crankcase fumes Into the inlet manifold. Disconnect the breather hose from the block breather, cover the outlet to stop you breathing shit and allow clean air into the breather hose.

  • @MK2GolfStories

    @MK2GolfStories

    8 ай бұрын

    Ah thanks for the info, could only go off rubber johnnys instructions as that’s all I had at the time. Thanks!!

  • @jyarrow29
    @jyarrow299 ай бұрын

    CO, not CO2. MoT tests don't measure CO2...

  • @MK2GolfStories

    @MK2GolfStories

    9 ай бұрын

    Whoops!! Your absolutely correct thanks I will Update the title

  • @MrStevecrasher

    @MrStevecrasher

    8 ай бұрын

    Yes, Carbon Monoxide, not Dioxide… BIG difference.

Келесі