No video
Adjusting carburetor on John Deere 314
Shows you how to reset the carburetor needles to factory settings on a John Deere 314 powered by a Kohler K321 14hp engine. Also, how to fine tune the needles and idle speed after you’ve gotten the factory settings restored. The mechanics are similar to other older small engines.
Пікірлер: 16
I know this has been four years but the info still stands. Thank you.
Great explanation, Adjusting my carb has always been a mystery to me, Thanks!
2:21 - PERFECT!!! Thanks! Ken
Good video. I would add to check the points gap, mine caused rough idle, backfire, loss of power, ect.
Thanks for the video, it was a big help.
Grate detailed information thanks 😊
Thx for the How-To, just change my carburetor on my Ariens S-14 K321S, set it like you sait and fire right up :)
Thanks for this helped a lot!
Good video
If you just did needle adjustment it's be a great vid. I however didn't know the carb pulled air in. Thought the piston in the cylinder (not chamber) did that.
@JasonMcGarvey
2 жыл бұрын
The piston does pull it in, through the carb.
Yeah that model of k series is a Post market K series by the air filter cap and the starter most likely from what I see a gear start not pulley generator so it’s a early 70s
What about adjusting a Walbro carburetor?
is their website show how to adjusting the carburetor john deere 300 series tractor
Nice video. I have a K341 in my John Deere 300, and it’s popping through the intake & exhaust, it seems....not sure what’s going on there, but it seems to stop doing that when I engage the PTO to run the mower deck. Any suggestions? I think I’ll start with doing these preliminary adjustments....
_ff&