Greetings from Japan! Saw the video a few weeks ago, ordered it, and installed it in about 15 minutes. Thanks Robot and the Vespa Motorsport team!

New year greetings to Radar and all the crew - from Joe in Perth, Australia. Thanks for all the great videos, tips and techniques.

@VespaMotorsport

3 жыл бұрын

Happy new year!

Literally took me 15min to knock out. Awesome vid thank you

On my GTS 300 (MY2019), it was easier to remove the fuse box to gain access to the USB connections and fit the PP11 harness as the necessary pug was clipped to the back of the fuse box mount !! Otherwise super easy mod and the PP11 harness makes it a very clean install. Thanks Robot & ScooterWest, keep up the great work !!

@ITSINSF

Жыл бұрын

I managed to take it out of the harness on a 2019, cables are held in place by a triangular harness that you can try to work out of … by sliding out and putting little force you can see them via the side vent tucked in . Hope that helps

Thank you Robot, USB socket and wiring already arrived and installed easy within 10 minutes. Everything works on my gts 300 perfectly. Thanks for installation video advice.

@VespaMotorsport

3 жыл бұрын

Great to hear!

@roberthecl8086

3 жыл бұрын

I made access to USB wiring by uninstalling blinker light - just advice for others.

Parabéns pelo seu vídeo, vespas eternamente. Um excelente ano novo para você e sua família. Do vespeiro DINELLI do Brasil

Last video for the year!! Happy new Year Robot! 🤖🍻🍻🍻

@VespaMotorsport

3 жыл бұрын

Same to you!

Nice option, Robot. Two points, though: (1) I've found the built-in USB port on my 2015 GTS300 does a pretty good job during my 30-40 mile jaunts for my phone (Samsung Galaxy S-10e now); (2) The limiting factor I've found in charging is the cable - the higher-quality the better. I found a flat cable that doesn't impede charging, but still allows the "glove-box" door to fully close and lock with little effort. (And, a quick plug for Quad Lock: have one, love it.)

Mmm that trail in the other bay😍

Happy new year Robot 👍👍👍👍

@VespaMotorsport

3 жыл бұрын

Happy new year

I know what I’ll be adding to my Vespa this spring.

@luis815tx

3 жыл бұрын

It's spring! hope installation goes well for you.

Buen vídeo felicidades!

Happy New Year 2021

Great T-Shirt!

Thanks Robot!

@VespaMotorsport

3 жыл бұрын

You bet!

I mounted a marine 12 volt socket on the side panel of my scooter cause it had a hole there the perfect size. I run a cb and tyre pump etc

I have Vespa Elegante VXL 150 it seems to get a bell ringing or metal noise from the Clutch area, this was bought a few days back as a brand new bike. Highly appreciate your thoughts on this :)

I ordered the parts based on the vid and even had Scooterwest pre-drill the hole, BUt after removing that lower panel I'm not able to get the cover to close. The rear of the USB plug butts against something. Is this made for the GTS300 Supertech 2021?

Hi Mr. Robot My Piaggio mp3 every came USB jack! I am going hook two UBS charges one to mirror mount & other one on side of body on scooter! I be hooking up solar panel on top case for keeping battery charges!

Robot, consider a vid upgrading the USB in the glovebox to 3.0. Thanks.

@TheCerealHobbyist

2 жыл бұрын

Agreed! Or snaking out the headset to a Qi charger mount. That is my next project.

Nice

@VespaMotorsport

3 жыл бұрын

Thanks

Any idea if and when you will have a version with USB C ports?

Sir can you make a video for the piaggio liberty S. How to we install charging on Liberty S 50cc?

I always worry about the cable getting tangled with that setup. My next mod to my scooter will be running power out of the headset right by the mirror and connecting the Ram Mount with Qi wireless charging.

Great movie thanks ! You sell products in Europa try Amazon ?

👍🏻

I have a GTS250ie. I installed the older kneepad USB kit that had a pigtail to connect to the alarm connector. I bought this same amazing faster USB outlet and put it in place of the older "Slow" USB and noticed that the wire in the alarm connector is a very small gauge. Will that small wire support the draw needed by the heavier wattage faster USB? Will I pop a fuse or toast wiring with the faster USB?

Can the harness be used for taking power to fit heated grips?

Is there a way to upgrade the USB outlet on a 2021 Primavera 50CC?

Do you have a connector to just upgrade the USB already installed on the Vespa?

Great vid... my 2010 steringlockndoesnt work what can i do also the glovebox doesnt open.

When fitting the 12v adaptor remember to fit it low to the right otherwise the wires can push against the square modules that are located inside to the left of the knee pad area.

So this plug will fit on the sprint primavera? The site shows only GTS models

Will this work on a GT200? thanks Robot!

😉😉😉👍👍👍

Hi, do you know, if it is possible to use this (or any other) kit to GT 2003 model?

How do I find the scooter harness for a 2012 GTS 300 super it looks different behind that panel will I be able to use the adapter harness that y'all provide pp11 plug & play my model Vespa doesn't come with a USB harness behind the panel

Hi Guys, can you do a video on how to remove and install Vespa Primavera Rear Mudguard please? The one that's attached to the rear tyre.

@VespaMotorsport

3 жыл бұрын

This video covers it: kzread.info/dash/bejne/pqynr6Oambjco5s.html

Do you have a part nbr for the predrilled complete kit?

Is it possible to use that connection to charge the Vespa battery?

To which electric line is the usb charger connected and can an additional headlight be connected to the same electric line?

Is this ok for the GTS300 Supertech 2020?

This clip is Designer approved ✅ 🛵❤️🤖

Can it be installed on a vespa S 150 2011?? Thank you!

When will these be back in stock?

Do they have a USB C plug in?

Would this work for a 2010 GTS 300?

will the voltage indicator be a parasitic drain?

@markcard7978

3 жыл бұрын

It has to have some drain to show the display, I'm more curious if it has any in the switched off condition. Since this has no "remote" turn on capability like TV's and such electronics I would suspect it does not and "off is off". I just swapped my Euro cigarette style outlet for one of these on my recently acquired Buddy 125. It has a 1amp fuse for the OEM switched connection so I ran an always on line from the battery with the SAE style heavy wire with inline fuse support to the 3amp capability of this unit.

Any possible issues for water to sip through the hole?

@VespaMotorsport

3 жыл бұрын

Shouldn't be any issues as there is a rubber gasket in between.

Bonjour. Je ne parle pas allemand : quelqu'un peut-il me donner les références de la cablerie "PP11" pour raccorder la prise USB ? Merci

Has not USB port this model inside?

Can I add to Liberty 150?

Hi robot 🤖 could this be done on a Vespa px 200

just remove the left turn light.....access easier

Are you able to get a navy blue seat for the Vespa 150?

Ram mounts suck peak design has the best phone mount