Any pointers on getting multi piece prints to fit together, mine never seem to fit at all
@MakersBestFriend
8 ай бұрын
What printer are you using ?
@bennyburden4326
8 ай бұрын
@MakersBestFriend it's a anycubic but an older model that's not made anymore, it's a clone of a anet a8, I've only been printing for about 2 1/2 months so got it from a friend as a starter to learn on, I use cura for slicing and have my settings at .15 wall thickness and 3 layers for walls and infill is set to 25%, I usually change my bottom layer thickness between 3 layers and 6 layers depending on what I'm printing but no matter what settings I think I might need to change I can't get multi piece prints to fit
@bennyburden4326
8 ай бұрын
@MakersBestFriend pt2, it prints really clean and layer height is set to 1.5mm, it's slow af though lol I can set it higher but suggested max speed on it is 45mms 😅
Пікірлер: 8
If you like Pirates of the Caribbean 👇
That is cool!
where did you get the model from
Definitely made of "wood"...... Yea right..
Any pointers on getting multi piece prints to fit together, mine never seem to fit at all
@MakersBestFriend
8 ай бұрын
What printer are you using ?
@bennyburden4326
8 ай бұрын
@MakersBestFriend it's a anycubic but an older model that's not made anymore, it's a clone of a anet a8, I've only been printing for about 2 1/2 months so got it from a friend as a starter to learn on, I use cura for slicing and have my settings at .15 wall thickness and 3 layers for walls and infill is set to 25%, I usually change my bottom layer thickness between 3 layers and 6 layers depending on what I'm printing but no matter what settings I think I might need to change I can't get multi piece prints to fit
@bennyburden4326
8 ай бұрын
@MakersBestFriend pt2, it prints really clean and layer height is set to 1.5mm, it's slow af though lol I can set it higher but suggested max speed on it is 45mms 😅