This video helped me tremendously, thank you so much!! I’ve been dealing with staggering and shifting and I finally figured it out!

Honestly never thought of that. Gona check the crossbar

Just watched your Xbox 360 controller bullet button mod from 11 years ago! It’s the first search on Google lol

perfect!!!

My Ender 3 V2 came with loose screws all over. There are 4 black screws on the X arm that hold the wheels to the frame. Remove the X gantry, make sure to untighten all 4 of them, push the wheels as far to the center as you can on the side where the lead screw is, tighten the screw thats normally hidden, put the X gantry back. Then you follow this guide sort of. You do almost exactly as he did here but instead of loosening the eccentric nut you tighten them and after that you fully tighten the black screws. This puts the V wheels in the right position making it so you don't even need to adjust the eccentric nuts anymore. Yes you probably still should tighten them anyway. Because those screws were loose any amount of leveling just didn't work. It would always unlevel after a couple of prints. I did this a while back and a couple days ago it unleveled again because the nozzle smashed into the bed and since I had not bothered with the hidden screw that was the issue. Now I have tried smashing the nozzle and it stays perfectly level. Just check those screws if you are having troubles keeping level.

I am new to printing and been having problems from the beginning and its very hard to find help!! Do u think this would work for the Voxelab aries?? I am to the point where I just wanna forget this one and get a auto leveling one!!

they say itss wrong becouse the bed is lower when its hot and contracts back when its cold, take the level with a warm bed. love the tips thanks bro

@Commandodesigns

Жыл бұрын

Yes, I agree. That's why you true the Crossbar first then level the bed. If you want to heat the bed before bed level, go for it. I don't think it makes a huge difference whether the bed is heated or not.