3D Printed Mini Outboard Motor + Propeller FT009 RC Boat
Mini Outboard Motor
Length 13cm
Hull Height 8cm
Matirial PLA+
Motor 2215 3200kv
Battery 2S Lipo 1500mha
Brass tune pipe 3mm
Drive Shaft 3mm
White grease
Cr.byedesing
www.thingiverse.com/thing:353...
Recommended customized print size 65%
Please subscribe to our youtube channel / @mr.rc-creator
Пікірлер: 137
Very nice build. It's hard to find an outboard motor prebuilt so this is a great option.
Just printed your model in PETG-CF and PLA (for the cover) at 125% for a 1/8 scale. Really good option as a test motor. Works a treat, so far nothing exploded or melted. Might upgrade the bevel gears to brass tho. Cheers
Awesome print. Can you put metal gears in. Wonder how long the plastic ones will last. I'm sure this took a good while to do.
Your 3D prints are totally under extruded dude. :D
Great build !! 🤗
I'm a new subscriber. I built this out board motor but I threw in some brass gears. I have a video out with it on a small boat runs amazing thanks for sharing this.
Desde florencia caqueta Colombia un gran saludo
Nice looking egg beater you have there!
Было интересно. Вот только мало в этом смысла. Попробуй сделать корпус лодки, установить, сделать измерения тяги, нужно будет увеличить длину дейдвуда, сделать антикавитационную плиту. А так конечно полще сделать просто мотораму и установить на дно лодки. Сделай водомëт!! Будет круто и можно использовать.
That's Flipping cool!
Yo lo quiero 😮😮😮
It's amazing. Great dude
Cool. But why have the phase wires come out of the back? Out the front would be more realistic.
Yeah.
Verry cool
Все хорошо,, но через валы воду будет поднимать наверх
Wires need to exit the shroud on the boat side, not rear of the cowling, otherwise spot on!
Need to build a volvo penta twin propeller outboard and inboard outboard system, 70% more efficient than a single blade propeller
That seems to have a lot of thrust would love to see it on a boat
Why not aim the wires the other way? Like...into the boat instead of out the back of it?