31 Minute Benchy on my DIY Corexy
Ғылым және технология
#3dprinting #benchy #voron #ratrig
I am recording the 2nd part of the 3d printer series and have a decent benchy printed in 31 minutes, I can go faster, but for the time and quality I am very happy.
Bigtree SKR 3 EZ with EZ TMC2209 drivers
LDO orbiter v2.0
LDO Voron motors
Pheatus Rapido hot end
Klipper
Пікірлер: 8
Secret link to a 19 minute run kzread.info/dash/bejne/ipWoyLCJh9Krh7w.html
3D printing is like magic to me. That looks lovely, I really like the detail on the chimney stack!
@leesmithsworkshop
Жыл бұрын
The programming to slice the solid object to layers is magic
Benchy go Brrrrrrrrrr
Looking at the print and I should remove retractions at layer change as well as increase the slow print speeds to stop those glossy sections. I could just set everything to 220 and see what happens.
@247printing
Жыл бұрын
Good job! You might also look at the accelerations/speeds for retracts and z-movement. I think your machine is capable for more (~25min. at same quality) with a bit slicer/firmware tinkering!
@leesmithsworkshop
Жыл бұрын
@@247printing someone asked about the pause on the chimney and I would guess that is retract at layer change. Yes I am sure with just a few simple changes I can get down to 25 min.
@leesmithsworkshop
Жыл бұрын
@@247printing I can see the Z hop is the delay so will adjust that.