2021 Can Am Outlander 850 Front and Rear Differential fluid change
Автокөліктер мен көлік құралдары
How I changed the Front and Rear differential oils in my 2021 Can Am Outlander 850 XT after the first 1,500 miles.
Get the oil pump here: amzn.to/3mRhNeB
(affiliate links) As an Amazon Affiliate I earn commissions from my links these small commissions help me to produce the helpful content on my channel
Royal Purple 75W90: amzn.to/3BKRjzn
Royal purple 75W140: amzn.to/307OrQi
If you found this video helpful and would like to show your appreciation hit the ($Thanks) button to leave a tip! :)
Пікірлер: 31
Great video! But remember Always remove the fill plug first! I have seen guys drain their diff only to find the fill bolt is either stripped or stuck.
Awesome video man! New to can am so I’m always looking for how to videos
@bikermike
5 ай бұрын
Awesome! Thank you!
How tight did you tighten the drain plug for the front diff when you put it back? you did mention it was lose when you took it off is there a specific spec torque you did to it or you just tighten it up until you knew it was good ?
@bikermike
2 жыл бұрын
I just used my own good judgement to re-tighten it.
Another great vid, Mike. I have the '21 outlander 570 XT with about 150 miles (240 km). I would assume the drivetrain is the same?
@bikermike
2 жыл бұрын
Thanks again! I can't say for sure but would think so, should be able to tell from my videos and comparing it to yours
Just did my 2019 Outlander XXC, what a pain in the @$$. Had to remove all of the skidplates to get to everything. No hole in the front (yet!). I did Wngine Oil, Filter, transmisson, front, rear diff, and removed the 4wd actuator to get to my speed sensor (2019) apparently different locations.
@bikermike
10 ай бұрын
They didn’t make things for ease of maintenance
Do you have the Visco-Lok? If so, is any friction modifier necessary?
@bikermike
3 ай бұрын
yes i do, manual didn't state that
Was this the first change or when did you do the first differential change?
@bikermike
2 жыл бұрын
first change
Hi, do you know part number of rear drain plug? Thanks
@bikermike
5 ай бұрын
Check on partzilla
What was that spray you used? What’s it for?
@bikermike
2 жыл бұрын
Just a bit of brake cleaner to flush away debris.
Why did the oil of this colour get water there?
@bikermike
9 ай бұрын
Not sure what you meant with your question. If oil is milky colored then you likely got water in it. May need to replace axle seals, or water came in from vent. 🤷♂️
250ml, do you see that? Then proceeds to overfill it. lol
@TheSponge945
Жыл бұрын
Rest assured, seals will be blown soon
Why did you fill it until it leaked out when it clearly says 250mls?
@mrknowitall777
2 жыл бұрын
Because when it starts to leak out its full just like all diffs lmao
@TheSponge945
Жыл бұрын
@@mrknowitall777 inexperience talking right there. Lol. There is a reason a specific level is supposed to be in there
@AustinHawkes-wo4fu
Жыл бұрын
@@TheSponge945 wrong. Working for a Can Am dealership. BRP instructs us to fill diffs until it start to leak out of the fill hole. Once the oil stops coming out, put fill plug back in.
@TheSponge945
Жыл бұрын
@@AustinHawkes-wo4fu so since you work for Can-Am that makes you the engineer and expert in diffs? Just because can-am dealer tells you to do, makes it right? Lol. Filling it over the stated amount creates issues where the seal blows out due to the excess fluid and no space for expansion. These diffs cannot handle extra fluid in them, good for you thought overfilling them as its job creation and keeping you busy replacing diffs and seals!
@AustinHawkes-wo4fu
Жыл бұрын
@@TheSponge945 this is coming right from BRP. Seeing all the differential failures is deemed to be caused by insufficient amount of lubrication. But just because I’m not an engineer doesn’t mean I’m wrong.
ya overfilled the rear lol. should be 1" below hole
one inch below fill hole...just sayin