can the coolant feed pipe(17mm) be re attached without the special en-49942 Hollow Screw Holding Wrench ?

@diyauto6258

3 жыл бұрын

Yes it can. I haven’t use the sst.

@EleazerMills

3 жыл бұрын

@@diyauto6258 Ok, Also, how important is the support bracket over the exhaust manifold? I got all 8 nuts on before I realised it was missing..

@diyauto6258

3 жыл бұрын

@@EleazerMills You need to put it on or you might need to replace components if you don’t.

how long of an extension do you need with the 17mm wobble socket? Can you replace the turbo without lifting the car up? Why did you have to replace the bolts? What size are they? Thx

@diyauto6258

6 жыл бұрын

Easy Company like a 6 " extension works. No vehicle can stay on the ground. I never picked it up. Replaced them because they can snap and they are 1 time use.

How can i make the blow out valve on my 2012 ecotec cruze make the noise wen it blows the extra air out ?

@diyauto6258

6 жыл бұрын

Erick Angeles you will need to look up aftermarket blow off valve.

@maplemechanic4464

5 жыл бұрын

Install a cold air intake filter, i did on my Cruze, sound effects are great!

@shidfard

4 жыл бұрын

You need a vent to atmosphere BOV. These 1.4l turbos come with a recirculating BOV. You can get a cold air intake to make the sound more aggressive. Atmosphere BOV will mess with the air flow sensor.

Why did u change ur turbo what was the problem..! If you let me know that would be great

@diyauto6258

6 жыл бұрын

Abdul Jameel Shaik vehicle was not performing to factory standers.

Hello, I have a 2011 Chevy cuze just replaced the turbo charger , and it still leaking oil, do you know what this is coming from.

@diyauto6258

7 жыл бұрын

ann miller . check your line's. including the crush washers that hold down the line. I you can add engine dye to the oil. let in run till it leaks,then use a UV/black light to find leak.

@annmiller3903

7 жыл бұрын

Thank you. I am in Gainesville Fl. are you anywhere close. thanks again, mostly likely taking it to shop this week, I will keep you posted.

@annmiller3903

7 жыл бұрын

you think it could be the oil line, the oil leaks in back to left

@diyauto6258

7 жыл бұрын

ann miller . no sir. West coast

@annmiller3903

7 жыл бұрын

Lol. thanks. I sure wish you were.

Hey holms you just take a few bolts out and it comes off then you put the new one on. That's it. That is literally all I got from this video 😂

@diyauto6258

4 жыл бұрын

Yes couple of hours.

Did you replace the two 17mm bolts from the coolant feed/coolant return lines that connect directly to the turbo?

@diyauto6258

4 жыл бұрын

Guercy Metayer, I did with the kit it came with. It comes with new hose and bolt

how much labor!!!!!!!!

@diyauto6258

7 жыл бұрын

Abdon Garcia . about 3hr