Dude the shop quoted me 1000$ and I finally found this video Man U saved my life I really appreciate the video quality

@PhillipBailey

2 жыл бұрын

Glad it helped you out. Did you do this yourself?

Phillip, thanks for ur time to show all this will help some people out there for share.

Great vid, just replaced my starter, same corroded wire. It's a lead from the solenoid to the brushes. New starter for $2 part because they couldn't be bothered to insulate the wire. The trick to get the starter out from behind the manifold is to rotate it as you pull it out of the bell housing and let the back end drop down and it comes out vertical. I didn't need to remove any brackets.

@PhillipBailey

2 жыл бұрын

Thanks for the tip. I think there may be a couple intake manifold variations depending on the year or even build date. There have been reports of being able to remove without the manifold being moved but believe me I tried everything on this. Could also be a variation on the oil filter housing not sure.

@ronyalefaio

2 жыл бұрын

I own one and its the most pain in the ass car to maintain..mitsubishi really needs to pay more attention about the little details in building their cars..its annoying

always feels good when you have good diag and better yet good quality parts

Hi good video, I also watched a few videos besides this one you made and I did the job. It'a not easy, it took me around 6 hours between getting the starter out and getting and installing the new one. Thanks

@PhillipBailey

Жыл бұрын

Glad it helped you. It is a challenge for sure.

Philip sir you are a legend

@PhillipBailey

3 жыл бұрын

That's not a pretty job that starter.

@3:50 ish he mentions removing the bracket, just remove the bolts that connect it to the plenum. If you look on the body just below the bracket, you'll see an out of place extrusion. This is a wedge point. Loosen the three bolts on the top of the plenum, the two mentioned above, and the one above the oil filter. Stick a wedge between the bracket and the wedge point. The starter will now wiggle out. Gotta undo and redo the connections at this point. If you try to do the connections where it's easy, it won't go back in.

Great job! Looks like a pain in the butt. Love your channel!

@PhillipBailey

3 жыл бұрын

Definitely not as easy as some for sure...

@philh9238

3 жыл бұрын

Neither are Honda’s the crv

If it comes back for the battery dying (slow leak) it is usually the Bluetooth module (located in the dash over the glove box)

@PhillipBailey

2 жыл бұрын

Already disconnected thanks

Faced the same exact issue, only thing was after changing my Starter Motor & Battery, my car wouldnt turn on at all. Cause of this, STARTER RELAY. Mechanic got it Bypassed and it doesnt have any issues.

Phillip, and waiting for part 3 of 06 F250/ 5.4 LT thank you brother.

I Always loosen the manifold to get to it. I have to give it to you guys up north. Looking at all that rust is discouraging to me.

nice going, your really good

Thank you very much for the detailed and informative video much appreciated

Dead battery could be due to bluetooth module draining battery when car is off. I removed mine and no longer have battery drainage...even after 10 days away with no starting.

@PhillipBailey

26 күн бұрын

@RocketRuss yes I'm aware of that and it has been disabled

Thank you so much

The blue tooth module is draining the battery

Does anyone know where he got the bracket from when he is showing the starter on the counter? I can’t find that bracket and my manifold still isn’t moving a single millimetre to get that starter out

@PhillipBailey

2 жыл бұрын

that bracket at 16:03 is directly below the throttle body seen at 13:40. There is also another brace seen briefly at 15:25 and 16:09 plus the bolts that hold the manifold to the cylinder head. HTH

I had similar symptoms ended up being the key wasn't turning off the engine immobiliser tried a different key and car started fine

@PhillipBailey

2 жыл бұрын

There are so many possible causes with the same symptom, glad you figured it out.

Also does anybody know how to disconnect the airbag system we had one malfunction and cannot get it replaced so we're going to put a monitor in there and just deactivate the system

@PhillipBailey

Жыл бұрын

You can't legally disable the air bag system in most states or provinces. Most problems that illuminate the warning light will result in the system not working in a crash if it needed to. What's the actual problem with it?

I have a 2010 Lancer GTS it's an automatic with the shift on the steering wheel got 88,000 miles on it and the other day at a stoplight it just jerk upon acceleration and will not go into gear at all it starts and runs just fine however I can't get the transmission to go into any gear and says Service transmission required but there is not really a code that my readers tells me has anyone else had a problem like this this

@PhillipBailey

Жыл бұрын

What scanner did you use? May need to use a better scan tool to read transmission codes. How's the fluid level and quality?

Do you think this will fix my u0100 code?

I have same problem for my lancer 2.0 4b11 non turbo. Can you send me the wiring diagram. Badly needed. Thanks

@PhillipBailey

2 жыл бұрын

Check out Alldatadiy.com they are pretty reasonable.

Mine is a 2006 evo 9, I got a new battery, and i changed the starter along with the starter ignition relay. because I use to have to hit the starter to get it unstuck so it would turn on. But now when I try turning it on it still won’t start, and by the second time I try cranking it you’ll hear a click from the starter but it’ll suddenly drain the power. and then theres no power inside the car. I’m not sure what it could be any help?

@PhillipBailey

3 жыл бұрын

Sounds like a loose ground cable. Check the battery connections first. Then follow the ground cable from the battery to the engine. Take the connection apart at the engine and clean it. Make sure the body ground is good as well.

@PhillipBailey

3 жыл бұрын

The body grounds are under the battery tray. See 18:30 in this video if this is the same as your Evo

My lancer 2008 de rough idle and vibrate at cold start what’s causing it thanks

@PhillipBailey

2 жыл бұрын

Could be lots of possibilities. Need to scan for codes, look at misfire data. Sparkplug, coils, injectors, mechanical problems in the engine. Start by reading the codes.

Hi, same issue with my lancer. Could it also be an immobilizer or ignition switch issue? Saw that you checked the ignition switch in the scanner so I assume that's how you can tell it wasnt the ignition switch?

@PhillipBailey

Жыл бұрын

You need to test for power being sent to the control terminal of the starter when it's not cranking. If it's an immobilizer issue you should have a code for that. Alternately you can test the stater by jumping pins 3 and 5 at the starter relay shown at 5:39 in the video. Relay could be labeled 30 and 87 as well. Be sure it's not in gear if it's a standard. If it does not crank and you have power at the relay pin 3 or 30 ymthe starter is likely bad. If it does crank the reinstall that relay and listen for a click from it when trying to start. No click control circuit problem...

@imagingteam

Жыл бұрын

​​​​@@PhillipBaileyanks! Tried to jump pins 3 and 5 and yup starter did turn and car cranked (didnt start). Just had it scanned recently and had an immobilizer short circuit code. Not sure if i should purse the immobilizer path...

@PhillipBailey

Жыл бұрын

@@imagingteam since it cranks by bypassing the starter relay then the problem is in the control side which could be the immobilizer. I would pursue the security issues. Does it have a remote car starter system that is aftermarket?

@imagingteam

Жыл бұрын

@@PhillipBailey no just stock security system.

Hey man, thanks for this video! Do you happen to know where the fuel pump relay is for the non turbo lancer? 2008

@PhillipBailey

2 жыл бұрын

As near as I can tell it's internal in the engine ECM and not serviceable. 2.0 litre. ETACS-ECU

@PhillipBailey

2 жыл бұрын

Sorry the ETACS -ECU is not the ECM but it's still not a serviceable relay.

@CC-gj9oj

2 жыл бұрын

Thank you so much for your help! I’ve searched everywhere and now can rest ez knowing I’m not missing it. Thanks man

Hey man I have a question. I have a 2009 2.0l lancer. Would the starter made for a 2.4l work for it?

@PhillipBailey

2 жыл бұрын

Sorry I have no idea. I doubt it but check with your parts department.

@trevlouie

Жыл бұрын

It looks like it does work

The low battery problem could be the Bluetooth module

@PhillipBailey

3 жыл бұрын

It's been disconnected already.

hey so I replaced the starter and still no start where should I start

@PhillipBailey

3 жыл бұрын

That's tough. Is the starter clicking at all. Do you have power at the starter relay. Can you get it to crank by bypassing the starter relay two large terminals? Battery ok? Cable connections? Maybe faulty starter?

@christianwiseman7252

3 жыл бұрын

@@PhillipBailey starter is good power everywhere I have checked a lot of connections its not throwing code either

@christianwiseman7252

3 жыл бұрын

@@PhillipBailey but I haven't trying to jump the starter by tapping the two together

@PhillipBailey

3 жыл бұрын

@@christianwiseman7252 at the starter relay listen and feel for the relay to click when someone turns the key to crank. If no click connect a test light between the two smaller terminals and try again. If the test light lights try a new relay. If it does not try moving the shifter to neutral instead of park. Use a piece of wire to bypass the starter relay by jumping the two larger terminals together. Make sure it's in park or if a manual in neutral.

@christianwiseman7252

3 жыл бұрын

im going to be honest I am fairly new at all this when you say terminal you mean the fuse right or the actual start its self

how much would it cost for a job like this?

@PhillipBailey

3 жыл бұрын

To change the starter is around 2.5hrs starter here in Canada reman is $250. Add some time for diagnosis of the system. I charged my customer $588.00 plus tax CDN. Hope this helps you.

@preludeguy100

2 жыл бұрын

588$ rip off

Isnt this ricks auto

@PhillipBailey

2 жыл бұрын

Nope, Phil's Mobile Service. Rick's Auto is about 5klm away...

@halogenisys4897

2 жыл бұрын

Ricks auto is right next to me i used to work there but thank you for the video!! Finally fixed the evo its alot harder with evos than the gts

not and easy job.