I Unseized an engine removing all the spark plugs & filling the cylinders with Diesel fuel, Let it soak for 2 weeks , charged the battery fully, then i cranked the engine over like 10 times every time i cranked it the engine turned just a slight bit, then the 11th time it broke free , I put the spark plugs back in & just like that the car was running great again, remember to change the oil after you do this.

@nunyabusiness776

Жыл бұрын

was your seized engine due to lack of oil or because it had been sitting there for a long time?

Excellent advice my friend!!! Thank you

Tou rock

Hey, I believe I have the same issue. I have no crank when trying to start it. My mechanic tried to run the engine and it didn’t turn the pulley like you did. I also got the same code from OBDeleven saying starter does not turn (mechanically or electrically disabled) do you think I might have the same issue ?

@strictlyaudis7012

2 жыл бұрын

Most likely yes but you won’t know for sure till you open the engine

Great video. I have the exactly same issue. My balance shaft was seized and caused my engine to not turn on. Same code I would get starter not starting mechanically blocked or electrically. Currently fixing the seized balance shaft and gaskets and carbon clean up. How as yours ran since replacing it? And what do you think cussed this ? My screen on the shaft were all broken maybe they weren’t getting engine oil ? And pressure broke them?

@strictlyaudis7012

2 жыл бұрын

If you’re able to open the engine , it would be the best because small partials will be circulating inside the engine and might cause problems , and do the piston rings job at the same time

@strictlyaudis7012

2 жыл бұрын

What city do you live in ?

@Nouvel509Haiti

2 жыл бұрын

@@strictlyaudis7012 hey where are you I need you to fix my Audi please idk any one who can help…

@strictlyaudis7012

2 жыл бұрын

@@Nouvel509Haiti my insta G is strictlyaudis

flush the engine...use only synthetic oil.After 500-1000 miles, change oil and flush, then drain oil and change oil and filter.

This one and this one and.. this one 😂 every mechanical component has a name. For example this one of the back of cylinder head is the vacuum pump.

@strictlyaudis7012

3 жыл бұрын

Hhhhhhhh yeah this one is a name that fits everything

Hey I try to crank it manually and it did crank a little bit then stopped, than I crank it the other way and it did but just a little bit, so do you have an idea why dosen't keep cranking?

@strictlyaudis7012

3 жыл бұрын

You could have the same exact problem I showed , you could have a jumped chain and bent valves ( to check is this is true you need to remove the camshafts and intake manifold then poor dw40 on the valves and see if it will stay , if it didn’t stay you must remove the cylinder head, if it stays no need to remove it ) then you need to ope the engine just like I did , free all gears from chains and see where the problem is . Good luck ,

@b13sentradfp37

3 жыл бұрын

Thanks I will do that

Did you need to disconnect the ac condenser in the front to pull the front bumper that far out?

@strictlyaudis7012

3 жыл бұрын

No I didn’t, the front end opens from top and gives you space but the bottom stays close to the car, also there are some rubber hoses that can stretch a little bit

@Jhugh17

3 жыл бұрын

@@strictlyaudis7012 okay good because I need to do my timing chain and didn't want to have to pull the motor due to space. But thanks I appreciate the response.

@strictlyaudis7012

3 жыл бұрын

@@Jhugh17 anytime, you can message me directly in my Instagram strictly audis and I will help you if you need help . My vedios show how to time the car properly

@Jhugh17

3 жыл бұрын

@@strictlyaudis7012 okay and will tho

@Jhugh17

3 жыл бұрын

@@strictlyaudis7012 added you on ig not sure if it's you because there's like several people with that ig name but my ig on there is e60_fasho

hi