1999-2004 Jeep Grand Cherokee IRO 4" lift front install
Putting a Iron Rock Off Road 4 inch Benchmark lift kit on a 1999-2004 Jeep Grand Cherokee WJ.
Жүктеу.....
Пікірлер: 37
@ftochris9653 жыл бұрын
You made it look so easy,would love to do this to my Jeep.Thank you!
@JF32304
2 жыл бұрын
It's really not that bad.
@DavidSanchez-ib4ft3 жыл бұрын
If and when you get death wobble, don't start throwing money on harder track bar bushings. The cause is the factory track bar bolts. You may not have noticed, but they are necked down bolts: i.e. the shaft by the bolt head is one diameter for maybe a few milometers/a few 16ths of an inch, and then it is a smaller diameter all the way to the threads. You can either measure the bolt diameter at the head and by the same size/thread pitch. Or you can weld the smaller part of the shaft and grind it round or use the strapping that they use to secure water heaters to the walls.
@mizellgg3 жыл бұрын
Great job showing all the steps 👍
@jeeploggernz22893 жыл бұрын
Ooohh nice one bro, very tempting
@benvin103653 жыл бұрын
Very helpful video! I will be referencing this when I lift my Jeep WJ. I'm interested in front and rear metal bumpers too. Where did you get yours?
@timschmoker30202 жыл бұрын
Love the "F Bomb" at 12:55.
@FastestIntegra
2 жыл бұрын
😂
@pauljacobs48043 жыл бұрын
Awesome !!! I know you have been wanting to upgrade !!!
@FastestIntegra
3 жыл бұрын
I tried to build strong and armor up before lifting.
@ickna20023 жыл бұрын
The upper part of the shock is not a stock thing I just installed my lift and it was just a nut that has to come out noting to do with a hex or anything else.
@damianpryor9703
Ай бұрын
same
@happyhotspring35013 жыл бұрын
Thanks for your informative WJ videos! 2 Thumbs-UP! I just got a 100% stock 03' WJ and noticed there are less 'ready-made'' upgrades on the market for the 1999 - 2004 WJ than most other Jeeps. Is there an upgrade Pitman Arm that could or should be installed with a 4" lift? How does the OEM Pitman Arm handle the angles at maximum articulation?... ...and how stable is it on the freeway?... ...Have you hauled any trailers with the 4" lift?
@kwmoore3464
3 жыл бұрын
With 4" lift the stock pitman arm will work. If you install a drop pitman then you will have trouble getting the steering alignment correct.
@riobravomultimedia41042 жыл бұрын
I wish you had just put some flat on the ground picks instead of at all flexed out stuff to see what it looked like maybe a before and after picture
@newlion70133 жыл бұрын
Do you have the bump stop spacers?
@ericfaley90193 жыл бұрын
IRO and a few others recommended the spring isolators be replaced when lifting. Also what size tire you running?
@FastestIntegra
3 жыл бұрын
IRO charges too much money for the spring isolators and other places don't have them in stock.
@ericfaley9019
3 жыл бұрын
I got mine through Amazon. In the end IRO would have been cheaper
@lest1872 жыл бұрын
Spring compressor will do
@EastSideGz Жыл бұрын
did this kit come with shocks?
@mikebaze15243 жыл бұрын
What size are the wheels, are you using spacers?
@mikebaze1524
3 жыл бұрын
I meant to as for tire size
@FastestIntegra
3 жыл бұрын
Tires are Radar Renegade R5 MT. Size is 285/75/16 with 1.5 inch wheel spacers.
@mikebaze1524
3 жыл бұрын
@@FastestIntegra thank you!
@mrmo6663 жыл бұрын
You sure those new control arms are installed correctly? Would make more sense to have the adjustable side with the grease fitting on the bottom.
@markcarpenter3600
3 жыл бұрын
Adjustable end goes on the frame side, protects them from damage.
@raularriagada60613 жыл бұрын
Estimado donde compro esos resortes?
@FastestIntegra
3 жыл бұрын
Iron Rock Off Road . com
@jeffreylowe47883 жыл бұрын
How would y'all compare this to the Rough Country lift?
@FastestIntegra
3 жыл бұрын
When I was shopping around and asking questions I had a bad experience with Rough Country tech support. Look at the build quality and the parts you get in the kits side by side. You will see that Iron Rock is a much more Superior product.
@FastestIntegra
3 жыл бұрын
I was recently at the Off Road Park 4 wheeling and another WJ had the full long arm kit from Rough Country his lift and tires weren't as large as mine and he was struggling going through the same trail.
@jeffreylowe4788
3 жыл бұрын
@@FastestIntegra Yes sir thank you! Great videos by the way. I heard a few bad things about RC and I haven't seen too many videos about IRO.
@jeffreylowe4788
3 жыл бұрын
@@FastestIntegra wow! That's just sad. Definitely not buying RC now
@markcarpenter3600
3 жыл бұрын
There's no comparison, especially if you plan to upgrade to the IRO long arms in the rear. The IRO rear long arm kit is a semi-triangulated 4 link. The RC rear long arm kit continues to use the a-arm for the UCA on the rear, and calls it a long arm lift! 'REALLY!' Also the RC rear long arm kit bolts to the bottom of the unibody frame rails, wher the IRO LCA's are recessed between the frame rails. If possible go straight to the IRO long arms front and rear. The IRC rear long arm kit gives a better ride than the short arms in the rear and articulation is incredible!
Пікірлер: 37
You made it look so easy,would love to do this to my Jeep.Thank you!
@JF32304
2 жыл бұрын
It's really not that bad.
If and when you get death wobble, don't start throwing money on harder track bar bushings. The cause is the factory track bar bolts. You may not have noticed, but they are necked down bolts: i.e. the shaft by the bolt head is one diameter for maybe a few milometers/a few 16ths of an inch, and then it is a smaller diameter all the way to the threads. You can either measure the bolt diameter at the head and by the same size/thread pitch. Or you can weld the smaller part of the shaft and grind it round or use the strapping that they use to secure water heaters to the walls.
Great job showing all the steps 👍
Ooohh nice one bro, very tempting
Very helpful video! I will be referencing this when I lift my Jeep WJ. I'm interested in front and rear metal bumpers too. Where did you get yours?
Love the "F Bomb" at 12:55.
@FastestIntegra
2 жыл бұрын
😂
Awesome !!! I know you have been wanting to upgrade !!!
@FastestIntegra
3 жыл бұрын
I tried to build strong and armor up before lifting.
The upper part of the shock is not a stock thing I just installed my lift and it was just a nut that has to come out noting to do with a hex or anything else.
@damianpryor9703
Ай бұрын
same
Thanks for your informative WJ videos! 2 Thumbs-UP! I just got a 100% stock 03' WJ and noticed there are less 'ready-made'' upgrades on the market for the 1999 - 2004 WJ than most other Jeeps. Is there an upgrade Pitman Arm that could or should be installed with a 4" lift? How does the OEM Pitman Arm handle the angles at maximum articulation?... ...and how stable is it on the freeway?... ...Have you hauled any trailers with the 4" lift?
@kwmoore3464
3 жыл бұрын
With 4" lift the stock pitman arm will work. If you install a drop pitman then you will have trouble getting the steering alignment correct.
I wish you had just put some flat on the ground picks instead of at all flexed out stuff to see what it looked like maybe a before and after picture
Do you have the bump stop spacers?
IRO and a few others recommended the spring isolators be replaced when lifting. Also what size tire you running?
@FastestIntegra
3 жыл бұрын
IRO charges too much money for the spring isolators and other places don't have them in stock.
@ericfaley9019
3 жыл бұрын
I got mine through Amazon. In the end IRO would have been cheaper
Spring compressor will do
did this kit come with shocks?
What size are the wheels, are you using spacers?
@mikebaze1524
3 жыл бұрын
I meant to as for tire size
@FastestIntegra
3 жыл бұрын
Tires are Radar Renegade R5 MT. Size is 285/75/16 with 1.5 inch wheel spacers.
@mikebaze1524
3 жыл бұрын
@@FastestIntegra thank you!
You sure those new control arms are installed correctly? Would make more sense to have the adjustable side with the grease fitting on the bottom.
@markcarpenter3600
3 жыл бұрын
Adjustable end goes on the frame side, protects them from damage.
Estimado donde compro esos resortes?
@FastestIntegra
3 жыл бұрын
Iron Rock Off Road . com
How would y'all compare this to the Rough Country lift?
@FastestIntegra
3 жыл бұрын
When I was shopping around and asking questions I had a bad experience with Rough Country tech support. Look at the build quality and the parts you get in the kits side by side. You will see that Iron Rock is a much more Superior product.
@FastestIntegra
3 жыл бұрын
I was recently at the Off Road Park 4 wheeling and another WJ had the full long arm kit from Rough Country his lift and tires weren't as large as mine and he was struggling going through the same trail.
@jeffreylowe4788
3 жыл бұрын
@@FastestIntegra Yes sir thank you! Great videos by the way. I heard a few bad things about RC and I haven't seen too many videos about IRO.
@jeffreylowe4788
3 жыл бұрын
@@FastestIntegra wow! That's just sad. Definitely not buying RC now
@markcarpenter3600
3 жыл бұрын
There's no comparison, especially if you plan to upgrade to the IRO long arms in the rear. The IRO rear long arm kit is a semi-triangulated 4 link. The RC rear long arm kit continues to use the a-arm for the UCA on the rear, and calls it a long arm lift! 'REALLY!' Also the RC rear long arm kit bolts to the bottom of the unibody frame rails, wher the IRO LCA's are recessed between the frame rails. If possible go straight to the IRO long arms front and rear. The IRC rear long arm kit gives a better ride than the short arms in the rear and articulation is incredible!