Пікірлер

• 
  @meaganlewis607713 күн бұрын

  Thank you a billion times over for taking the time to do this video as I was able to use it to familiarize myself with where to find everything My only struggle was removing the oil filter as I tried for far too long to turn it the wrong way and now I can't even remember if it was turned to the driver's side or passengers side so I hope in 6 months when I do it again that I figure it out faster

• 
  @syedferdousahmad18 күн бұрын

  Great video. I followed your instructions and changed my 2016 kia soul's oil. Now the question is how do I reset the oil change sensor light that is still on? Any suggestions?

• 
  @22vahАй бұрын

  Aren't you suppose to replace drain pin nut after each oil change to minimize potential for leaks?

• 
  @richardvalentine3974Ай бұрын

  Nice job, buddy! You made it so easy for me to do it myself. God bless you and yours'!

• 
  @bigcconservativeguy25346 ай бұрын

  The correct torque spec on the drain plug is 25.3 ~ 32.5 lb-ft and on the filter (no one ever uses this lol) is 8.7 ~ 11.6 lb-ft. Hand tight plus about 1/2 to 3/4 turn after the filter gasket has seated.

• 
  @bigcconservativeguy25346 ай бұрын

  You need to replace the crush gasket as well. They're cheap and called a "crush" gasket for a reason. They are generally not reusable! They're just an M14 gasket and usually come in packs of multiples for as little as $6 CDN

• 
  @bigcconservativeguy25346 ай бұрын

  You dont need to remove the entire under panel. Just those 2 covers will give you all the access you need.

• 
  @jamiecapdevillasantiago6 ай бұрын

  Thank you very much, super helpful!

• 
  @ericandre80 Жыл бұрын

  great video

• 
  @bama1gem Жыл бұрын

  Should you have changed the copper compression gasket on the oil pan plug? I noticed having the vehicle on the ramps, you elevated the front of the car, the oil plug drain is on the wrong end of the oil pan and old oil is left in the vehicle, with that design, it really needs to be up on a lift where the pan will drain properly. You also didn't mention what engine that is, 1.6 or 2.0. I'm going to assume it was a 2.0, because I just watched another video that was different and it was a 1.6. Maybe they only made one engine in 2016, I don't know. I just bought a 2016. Thanks for your video.

• 
  @bigcconservativeguy25346 ай бұрын

  Yes, always change the "crush" gasket. They're called a crush gasket for a reason and are seldom able to be reused generally resulting in a slow drip leak! Seeing as he used 3.8 liters of oil that would make this the 1.6l engine.

• 
  @jamesrice-qc8xx Жыл бұрын

  New crush washer ?

• 
  @bigcconservativeguy25346 ай бұрын

  Always!

• 
  @20Jay20 Жыл бұрын

  How hard is it to open the panels on the undercarriage and to do ot with it on?

• 
  @quintendoty5591 Жыл бұрын

  Possible but might need better tools cause a bit more tight. Never had to do that since coyote ran in front of me before I even made the first payment

• 
  @rmajor1515 Жыл бұрын

  Great video thanks

• 
  @brute6896 Жыл бұрын

  God that oil plug position is awful

• 
  @watchwomandebrajesusistheway Жыл бұрын

  Thanks

• 
  @nocrust4865 Жыл бұрын

  nice cover brother

• 
  @quintendoty5591 Жыл бұрын

  Thanks man!

• 
  @daneshanoski4705 Жыл бұрын

  How the heck heavy is that stone ball

• 
  @quintendoty5591 Жыл бұрын

  Buck 03

• 
  @NoEffsGivenfr Жыл бұрын

  Hahaha 😂

• 
  @lisalee2738 Жыл бұрын

  Thanks for the video

• 
  @Radsmachine Жыл бұрын

  I know it's an old video and my oil pan and dip stick are a liitle different from yours; but this video helped me so much! I was tired of paying someone $70 to change this oil. So I went to wal-mart and spent $26 for oil and another $9 for a filter. Thirty-five dollars and about thirty minutes later my oil is changed! Also, the filter is far different from the one That I took off of it, so the shop that did it before may have installed the wrong one....anyway, Thanks!

• 
  @quintendoty5591 Жыл бұрын

  🤘🤘 very good! Glad I could help :)

• 
  @user-fk5vv5sx3t Жыл бұрын

  ه

• 
  @g1967 Жыл бұрын

  Good job...sounds great..bad title?

• 
  @quintendoty5591 Жыл бұрын

  Thank you!! Idk it's pretty dang loud. Just looking out for my headphone friends. Maybe I'll adjust it in the morning

• 
  @julied1547 Жыл бұрын

  I love hearing you play and sing! Made my day

• 
  @quintendoty5591 Жыл бұрын

  I hope you did not have headphones in

• 
  @NickKouls Жыл бұрын

  Fantastic cover..!

• 
  @nathanielbrantley935 Жыл бұрын

  Thank you great job

• 
  @LukeMcHale Жыл бұрын

  quinten cool cover of nutshell! like 3!

• 
  @quintendoty5591 Жыл бұрын

  Hey Luke! Thanks a ton, it means a lot!

• 
  @alexluna7810 Жыл бұрын

  Excellent video,thank you for sharing it here,I had to do oil change on my wife's kia soul and this video was perfect for the job !

• 
  @hbj448812 жыл бұрын

  Thanks for the help.

• 
  @outrageouzfg2 жыл бұрын

  Awesome video. Thanks for the tips! I own a 2014 Kia Soul myself

• 
  @corneliojacobo38782 жыл бұрын

  Does these vehicle have a re set button for oil change

• 
  @FluidITGuy2 жыл бұрын

  Have those plastic ramps failed ever?

• 
  @quintendoty55912 жыл бұрын

  I'm not going to sit here and say that they have never failed in the history of them being around, but the ones that I have are pretty sturdy. They look like its just a shell of plastic but there is a lot of reinforcement pieces. As long as you are setting it up correctly, I would say you would have to want it to fail for them to fail. The brand I have is RhinoRamps. If you google Durable RhinoRamps it will pop up. From its description: "Easily holds up to 12,000 lbs."

• 
  @nathanmooney82062 жыл бұрын

  Thank you for the step-by-step instructions.

• 
  @agnelcruz75152 жыл бұрын

  You r contaminating the water by putting so much food for such few fishes Just put a pinch that's enough.

• 
  @quintendoty55912 жыл бұрын

  I think I put a bit much in there for the video but typically I put enough for them and I will watch to ensure they eat it all (To adjust for future feedings). Thanks for watching and commenting!

• 
  @agnelcruz75152 жыл бұрын

  @@quintendoty5591 yeah bro take good care of the cuties....

• 
  @charlesaspen51202 жыл бұрын

  Can you say more about how to get your car far enough off the ground safely? It will be my first time trying this and I don’t want an accident!

• 
  @quintendoty55912 жыл бұрын

  Ramps are pretty straight forward. You put them in front of your front tire and drive up them slowly. Most of them have a bump at the front so you don't go over it, but as long as you are slow you should not hit it. You can feel it sit into the ramp once you are at the top. If you are using a jack, I recommend looking up other videos on how to jack up the Kia soul. kzread.info/dash/bejne/lZqhu6acl6zWoNI.html This video seems to give good examples and spots you can put a jack without damage. Hope this helped!

• 
  @bigcconservativeguy25346 ай бұрын

  And always chock the rear wheels!@@quintendoty5591

• 
  @nocrust48652 жыл бұрын

  ggwp

• 
  @samuelmuldoon48392 жыл бұрын

  I do wish you would show a video on how to remove the under-body plastic panel and put it back on again. "Under-body" might be the wrong term to use. Maybe it's called a "belly pan." Anyway, I do wish I knew how to get rid of the flat black plastic panel from the bottom of the car.

• 
  @quintendoty55912 жыл бұрын

  Hit a coyote at 75mph to remove bottom plate.

• 
  @bigcconservativeguy25346 ай бұрын

  its like 8 bolts, nothing to it. They're all obvious and easy to access.

• 
  @Aquafinity2 жыл бұрын

  Awesome video! 👍 👍

• 
  @quintendoty55912 жыл бұрын

  Thank you! 👍

• 
  @amandaberger69812 жыл бұрын

  LOL

• 
  @Yeosh2 жыл бұрын

  00:20

• 
  @quintendoty55912 жыл бұрын

  00:21

• 
  @Muziclush20123 жыл бұрын

  I like the fishys. Can you start a Twitch.tv stream please. :)

• 
  @Artsoulvision3 жыл бұрын

  Do you save money by doing this?

• 
  @quintendoty55913 жыл бұрын

  Most certainly! Around here synthetic oil change is like $60-75 for someone else to do it. Usually the filter and oil have some 'sale' where you get them together for like $30-35. Takes an hour of your time(if you count cooling the car in your driveway) and you know its done right when you do it instead of a shop.

• 
  @Skyfall-sv8df3 жыл бұрын

  Good video. Using ramps angled like that aren't you leaving a lot of oil in the pan?

• 
  @quintendoty55912 жыл бұрын

  I know I'm 10months late but figure I address this now than never. I have tested before by down the ramp to see how much comes out. its a dribble at best. maybe if I backup onto the ramps more would come out but 6~ oil changes I have had no issues and don't see any reason not to use ramps(A lot easier than a jack and some stands in my opinion).

• 
  @paigesimmons62903 жыл бұрын

  Thats actually really good-the girl from omegle

• 
  @RJDCR3 жыл бұрын

  thanx , and my SOUL thanx U aswell...Rock onnn

• 
  @quintendoty55912 жыл бұрын

  Rock on!

• 
  @haranalvarez31283 жыл бұрын

  If you don’t want to make a mess when pouring in the oil you can set the dip stick to guide the oil into the motor. :)

• 
  @showdivine4 жыл бұрын

  Thanks! Blessed.

• 
  @quintendoty55912 жыл бұрын

  Thank you too!

• 
  @jonpiotrowski35064 жыл бұрын

  Great video...now that I’ve had my last freebie from the dealer,I’ll be doing it myself...keep up the Soul videos....an Excellent video,to the point,no unnecessary stuff...BTW,is there an o-ring,gasket or washer on the oil pan plug to help seal the threads...?

• 
  @quintendoty55912 жыл бұрын

  Glad to help. Hope that you have been doing all your own oil changes! I honestly cannot remember if there is a crush washer or not for my car. I know my motorcycle has one but been too many hours since last oil change.

• 
  @848zachary4 жыл бұрын

  afterwards, you should reset the oil life monitor

• 
  @quintendoty55912 жыл бұрын

  My car doesnt have that. or at least it has never popped up on my dash

• 
  @rosez10144 жыл бұрын

  Four quarters ?

• 
  @quintendoty55912 жыл бұрын

  = $1.00

• 
  @watchwomandebrajesusistheway Жыл бұрын

  @@quintendoty5591 😆

• 
  @jimbrown3414 жыл бұрын

  Nice job! You're really prepared with all the right equipment.

• 
  @quintendoty55912 жыл бұрын

  Mise en place