Пікірлер

• 
  @jrmbtr15 сағат бұрын

  Do you think this is worth doing on stock speakers?

• 
  @taifmunsurКүн бұрын

  Why didn’t you do bilsteins 5100?

• 
  @bigcheese40067 күн бұрын

  Does this disable TSS?

• 
  @totalannihilation90659 күн бұрын

  Nice plate idea, although instead of paying 20 bucks I found a plastic part in my Garage and dremmeled into shape. Glad I watched your video.

• 
  @k.skyl1n3zz10 күн бұрын

  the vehicle is most loud from the floor I believe. and yes the floor is going to make the most noticeable difference. But I also recommend to always have Closed PE Foam on every butyl area you put it in especially the doors, because those actually do deaden the noise, butyl itself won't help much but reduce resonance only.

• 
  @Specz18714 күн бұрын

  Thats a great little item from etsy. I wondered where and how to mount a rear cam in my 2015 4runner, now i know. Thanks

• 
  @juliuscafe14 күн бұрын

  what is sealant your using you have a link?

• 
  @danyang333614 күн бұрын

  I used butyl tape. 2 years later holding up great! amzn.to/3S3UugD

• 
  @RachaelTiow26 күн бұрын

  The install was not pleasant. Tight spaces and fat fingers.

• 
  @RachaelTiow26 күн бұрын

  Thank you for this video!!

• 
  @ericville62Ай бұрын

  Thanks Dan for taking the time to demonstrate how to run the rear camera, much appreciated!

• 
  @slh48Ай бұрын

  They have a amber now👍👍👍From all the videos I’ve watched LasFit makes great LED bulbs for your whole vehicle and that’s great for the money there lights bars cost they don’t have problems with conversation in the light I do know over the years like headlights if you drive a lot and they sell those had like kits that’s a waist of money when your headlights are scratched up rocks hit them from just a normal wear and tear driving and I did see a video where you can buy film thsts pre cut for headlights and taillights but that’s what I was to find out about lasfit there light bars that’s great you can get them for like 100 bucks even if you had to buy a new one every three or four years that’s not that bad if rocks hit The lens and crack it that’s the only way I’m sure you would get condensation and have any problems but yeah I’ve seen one Amazon if you search around because there’s a third-party sellers some people sell them for a little more than other people and sometimes you can buy with the brackets some people don’t give them to you with the brackets from what I’ve seen they definitely have Amber light now and there Led head light fog light switch back there front blinker switch back bulbs and tell lights reversed lights and your tag lights bulbs all of them are so bright and made very well

• 
  @HeavyChevyMegaАй бұрын

  Do you know if anyone makes a dashcamx mount for the rear camera on a 3rd generation Tundras (2022-24)? Thank you

• 
  @kyllehardzog7265Ай бұрын

  I'm curious.. your rear cam footage has a date/time stamp but your front cam footage doesn't. Is it possible to change this in the app settings and have the date/time stamp on the front cam footage as well?

• 
  @alxusmcАй бұрын

  How do you alternate the switchback lights if you’re connecting to a panel without the switch?? Thanks!

• 
  @t4rdave19 күн бұрын

  Wondering the same thing

• 
  @danyang333614 күн бұрын

  Amber and White lights are wired with two different wires, I wired amber to one switch and white to another switch.

• 
  @8elalacranАй бұрын

  What year it’s your 4Runner ? Will this be the same for A 2024 year ?

• 
  @danyang333614 күн бұрын

  Yep! Same install

• 
  @tuckerhiggins4336Ай бұрын

  Got my 4 doors done. Still need to do the rear hatch. Want to do the rear cargo bay and wheel wells, but that is a bigger undertaking. Used the same stuff you used. I can't say it is quieter, but the noise doesn't come from the sides anymore if that makes sense

• 
  @danyang333614 күн бұрын

  I noticed the same thing, the sound is more controlled and I can hear my music much more clearly.

• 
  @tuckerhiggins433614 күн бұрын

  @@danyang3336 Speakers are definitely better

• 
  @Dizzy0214Ай бұрын

  Whats the link for the crutchfield harness? It does not work when I click on it

• 
  @JoBiatchАй бұрын

  Hey do you think having all that glue and foam will kill you?

• 
  @klumsytone2 ай бұрын

  Did you contact Lift Support Depot for help finding the right size or did you just use the filter on the website?

• 
  @chuckmargaris94582 ай бұрын

  How about actually showing how it looks

• 
  @jesusolguin4642 ай бұрын

  I know it was 3D printed for a 4 runner but will it also fit on other Toyotas, for example, a Toyota Corolla or a Camry? Thanks for the great install video!!!

• 
  @anthonyviscusi40422 ай бұрын

  I'm trying to figure how much material to get. The Amazon basic 18x32 comes in 9 pieces. How many pieces do I need for the 4 doors and trunk hatch? Thank you.

• 
  @danyang33362 ай бұрын

  I used 8 sheets to cover my doors and hatch

• 
  @saud43912 ай бұрын

  Hi Dan thank you for this video and hope you doing good ...should I change the upper control arm for this lift kit ? And have you ever face a problem for this lift ?

• 
  @SarahSerrano-oh2xr3 ай бұрын

  @danyan3336 how many pins was your adapter? I have a 2021 TRD ORP but not sure on what adapter I would need. Do you think the 10pin type-H would be compatible? Please let me know!

• 
  @danyang33363 ай бұрын

  amzn.to/3xAwWIN

• 
  @SarahSerrano-oh2xr2 ай бұрын

  @@danyang3336 Did the install, very low profile. Thank you! Learning so much with your videos!

• 
  @brandonr253 ай бұрын

  What can I use if I have jbl system?

• 
  @bernolieniegos10973 ай бұрын

  Where did you bought those rubber inserts..Thanks

• 
  @rubenmaldonado14733 ай бұрын

  Where do I but it

• 
  @Changwoong2Jhon3 ай бұрын

  Were you able to see the license plate with the rearview camera at night and day?

• 
  @user-gr4wm5mv5p3 ай бұрын

  I did on this my 2018 ORP and it was well worth it. I now have a 2022 trd pro and will do the same mod. Lesson learned: too much deadening on the hatch can weigh down down the door where the struts can't handle it.

• 
  @jesseoverlin4379Ай бұрын

  getting ready to do mine. how was the process? how much is too much for the rear? did you do floors?

• 
  @user-gr4wm5mv5pАй бұрын

  @jesseoverlin4379 I didn't do the floors beacuse it's too much work. ~60% coverage should do it for the rear hatch. You don't need do 100% on the doors either. I would do ~80% on doors. The key is to clean it well, use the right tools such a roller, and wear gloves. The hardest part was installing the door panel but I think there's a recent video how to do it easier taking off the attachment clips at the top of the door panel and install the first and simply push in the door panel.

• 
  @jesseoverlin4379Ай бұрын

  @@user-gr4wm5mv5pdid you do the foam too or just the deadening?

• 
  @user-gr4wm5mv5pАй бұрын

  @jesseoverlin4379 I did the foam too. I'm not sure what difference it makes though.

• 
  @counterbalancelife43053 ай бұрын

  looked like about a 3 decibel difference which is a big decrease in loudness. I'd call it a success.

• 
  @tuckerhiggins4336Ай бұрын

  logarithmic scale, 3dB is good

• 
  @DB-ks6mp3 ай бұрын

  Thanks for the vid! Gonna put one in my venture soon!

• 
  @kouyang19203 ай бұрын

  Brother hmong!!

• 
  @danielpeterson97193 ай бұрын

  While installing the front camera I broke off one of the mounting tabs. Anyone know if there’re replacements for just the camera case?

• 
  @sinamorid76004 ай бұрын

  Says I need a hardwire kit in order to activate park mode. Any way around this?? For Rove Pro

• 
  @sinamorid76004 ай бұрын

  Does this drain your car battery when the car is off?

• 
  @antonymaraziti31754 ай бұрын

  Was it easy to reapply the plastic film inside the door panels? Did you need to use any tape or anything? Thanks

• 
  @gurdip40754 ай бұрын

  How hard was it to actually slide the box into the new location, the wiring seems a bit tough to move.

• 
  @KeokiDude4 ай бұрын

  I just bought that mounting plate off Etsy- thanks.

• 
  @user-km6fm2il3k4 ай бұрын

  Can you also use this on a Rav 4 2022? 7:16

• 
  @user-km6fm2il3k4 ай бұрын

  Can you also use this on a Rav 4 2022?

• 
  @jhayt4r4 ай бұрын

  Valve stem sticks out past rim lip?

• 
  @user-lq9ts9qr8l4 ай бұрын

  my put on 4 runner 2023 sr5 and colision radar sensor front gril give my woring the go out for sefty colisn my take off after all car worc oem from factory the cam look good and no my like brocen factory voranty car only 9000 mil

• 
  @adventure_dogwagon5 ай бұрын

  Is the Install the same for the TRD Pro?

• 
  @michaelvinal14725 ай бұрын

  Any suggestions for a 2012??

• 
  @josuemartinez88175 ай бұрын

  Awesome illustration. Very detailed video.

• 
  @RandyRicher5 ай бұрын

  Put them on my 2016 Four Runner. Some problems. The gasket that came with the LED was too thick and could not install in the housing. I had to use the old gasket off the OEM bulb that I was replacing. That worked good. Another issue was the connected can be plugged together with the wrong polarity. I had to unplug and flip the connector on the one side. The dust covers are very tight to twist on for installation. Bulb works great and is very bright and everything is aligned properly. I just disappointed with the gasket being too thick.

• 
  @whapaso5 ай бұрын

  Can I borrow your slender fingers?

• 
  @kevfield25515 ай бұрын

  I noticed the Dongar kit says 2020+ when I click on the link from Amazon. is there a different adapter for 2018?

• 
  @Treetopflyer7774 ай бұрын

  That’s what I’m looking for. Mine is 2018 and doesn’t look like this one …

• 
  @amon21128 күн бұрын

  Same. Everything I'm finding for this type of adapter goes into the newer models/ones with a different mirror setup. Have you found one from somewhere else? ​@Treetopflyer777

• 
  @_ezra62175 ай бұрын

  So you have to remove the external trim and can't reinstall it after?

• 
  @sayforee5 ай бұрын

  Can you get live footage when you are away from the car through the app?

• 
  @NoblesTx5 ай бұрын

  No that would require power all the time which wouldn’t be possible without a hard wired fuse but even then idk if you can run it live while away