Пікірлер

• 
  @DeniseGrothman22 күн бұрын

  Thank you again. Dan!! We had so much fun visiting you and learning about this craft! Best to everyone who welcomed us~

• 
  @alanhurdle394927 күн бұрын

  Prefect in your career you must on the first time haha I no good lol

• 
  @ironsights4me4 ай бұрын

  You overcharge because you obviously overcomplicate. If that newell cap didn't cost so much he would've had to finish it quicker...

• 
  @rgtn24414 ай бұрын

  You over complicated that newel post . Doubting your shop doesn’t have another tablesaw ( non sliding panel saw) if it’s a right tilt, put the fence on the other side of the blade to run your bevel. Nothing to report on the shaper operation other than climb cutting the cove to reduce tear out . Adding an additional fence on the opposite side of the shaper wouldn’t have been a bad idea either

• 
  @ahmadmuhsen944310 ай бұрын

  very good work bro

• 
  @fredstevenson139011 ай бұрын

  I ne r d label all m y ladders

• 
  @noebarrera106 Жыл бұрын

  Where did you get the soft closed ones for bifold ?

• 
  @kevincradock Жыл бұрын

  It's the Salice Concertina bifold with soft-close

• 
  @camiloguzman9049 Жыл бұрын

  I bet that this video will blow up exactly in 1 year

• 
  @xxDOTH3DEWxx Жыл бұрын

  Can't hear a thing he said

• 
  @brian578 Жыл бұрын

  How much was the bid

• 
  @anallesespeciale1315 Жыл бұрын

  🄿🅁🄾🄼🄾🅂🄼