Dave Bode

2 жыл бұрын

Headrush MX5 Ambient Pad Rig! Super long sustain with Dynamic Delay!

Пікірлер

@sbrave10 күн бұрын

I'm going to check out the SLO-100. I use the MX5 with a Mesa 1x12 cab and an OwnHamer cab sim. A lot of the time, it sounds good at home, but bad at gigs, very thin and sh!tty, esp if I take an output to the PA even with the ca sim. Also, the whole thing of having to use 2 of the same amps to switch between clean & dirty without lag has become a hassle, and the levels never really match. Maybe I need to just use a clean amp and a couple of these overdrives as you show here. Thanks!!

@herroglop74112 ай бұрын

Does the Mx5 not have already a "freeze" pedal, called hold among the available effects?

@artcoreplayer2 ай бұрын

are you running your guitar into the cali 76 before the MX5? I'm assuming so but just wanted to confirm.

@ArtStiefel3 ай бұрын

🎸Thank you for the well explained set up. Great insights and ways to approach setting up the pedal.🎸🎸🎸🎸🎸

@rockongoodpeople3 ай бұрын

great job Dave - really well done and broken down and explained - u rock! Take care! -DT, NLG

@adrianflores40363 ай бұрын

I love your videos! Thank you! I think the talking is the perfect amount, btw! Haha I have the Headrush Gigboard and I wish the community was bigger for Headrush! I feel like a tiny community and much smaller being a Worship Leader with the Gigboard!

@PocketDelicious4 ай бұрын

What's the equivalent delay for this on the Helix? I do have an MX5 on the way that I'm pretty excited about.

@NINERS8able5 ай бұрын

How do you actually hook the distortion pedal to the headrush? I use 2 FRFR speakers for stereo as well…

@DaveBode5 ай бұрын

Guitar>Dist pedal>MX5>FRFR

@___KS___5 ай бұрын

you forgot to give a link to the rig you made))

@metalheadblues5 ай бұрын

Do a high gain video pls

@falkinj6 ай бұрын

Dave, this is great stuff! I'm loving my MX5, but I'm a drummer turned guitarist, so I'm learning not just about the unit, but about the chaining of various effects. Thanks for some great videos!

@mohitrahaman6 ай бұрын

Ambiet sounded really good

@louaguado9957 ай бұрын

Maybe a bbd (bucket brigade delay) supposed to work that way? You should have compared it with the analog and digital delays on the same pedal to compare it.

@Megzamani7 ай бұрын

Thank you

@hannesolivier2047 ай бұрын

Would you rather put the dist/od pedal before the input or in as an fx loop so that you can control where it’s inserted in the signal path?

@ymelfilm7 ай бұрын

HI, Can you use the looper easily in live scenarios? LIke a one man band?

@ymelfilm7 ай бұрын

what is the quality of its virtual capo? Useless?

@DaveBode7 ай бұрын

Virtually

@tiagopanda20108 ай бұрын

This preset is amazing. May you share it ?👍

@sbrave8 ай бұрын

I have the MX5 as well. Would you sill need to have an amp active in your rig when using an external overdrive? Would be nice to just have a clean fender twin, etc in the rig and use an external drive to go from clean to dirty. This also would eliminate the known delay in any of these modelers when switching from a clean to dirty amp.

@DaveBode8 ай бұрын

You don't need to have an amp. When I had the MX5 I did not notice any delay switching between 2 amps. You have to have 2 separate amp blocks for gapless switching. If you switch the amp via the preset fuction with a scene, there will be a gap.

@sbrave8 ай бұрын

I have a scene with 2 Soldano amps, 1 clean & 1 dirty. Only one is ever on, but when I switch off the clean and enable the dirty, via a scene change, I definitely hear a gap/delay. Am I missing something? Thx!@@DaveBode

@DaveBode8 ай бұрын

@@sbrave I don't have my MX5 anymore but I do not recall a gap in switching on and off amp blocks unless some other effect is switching a preset within the scenes function. Any block preset change via scenes will cause a gap.

@sbrave8 ай бұрын

@@DaveBode Actually....there's an overdrive block that gets kicked on in the dirty scene, as well as the dirty amp. When I took it out, the gap is gone. I'll fool around with some amp settings to see if I can just use that overdrive block for solos, etc. Thanks man!!

@JAPDEV8 ай бұрын

Hello, I am a newbie as a guitarist and I have acquired a headrsuh mx5, total disappointment (perhaps because I am very new), my headrush I don't know if it is defective :D but it doesn't sound good, the bass sounds terrible, it lengthens, and very low I try to equalize but nothing helps, I suppose it's a configuration thing, but I can't know or find a place to configure it in a standard way, could you tell me a tutorial that would help, I've searched on KZread but nothing helps me, thanks for your video.

@DaveBode8 ай бұрын

Here is a link to my last backup of the MX5 with all my patches. Download it and copy over some of the patches to your MX5 (drive.google.com/file/d/1qQuI__l4abUlhopzZMUza5Dm-n8uMHgV/view?usp=sharing) One thing that will help is registering your pedal and downloading the free Celestion IRs (celestionplus.com/redeem-serial). There are download and installation instructions here (kzread.info/dash/bejne/i6Z6ms6eere2abQ.html). For any of my rigs that have missing IRs, load one of those selection IRs. If you still think they sound terrible, it is likely either your monitoring setup or your guitar. You should be using something fairly neutral to monitor the MX5 like basic studio monitors or decent headphones. If your guitar sounds terrible, try a different guitar. If you find that the rigs sound much better with a different guitar, you might be able to put an EQ as the first block and adjust the frequency response of your own guitar on all the rigs. If that's the case, EQ it to sound better, save the EQ as a preset, and re-arrange all the rigs to have that EQ as the first block. It is important to correct your guitar's frequency response with an EQ on the first block!

@JAPDEV8 ай бұрын

Thanks so much!@@DaveBode

@ironvip8 ай бұрын

Dave, I cannot express enough how important your videos were for my journey in the amp modelers world. I started with MX5 a few months back and was completely overwhelmed by the amount of knowledge required to set it up properly to make it sound as you need it. I wanted to give up and send the headrush back being convinced there is something wrong with unit and not my skills... a typical newbie mistake - looking back from the perspective. Even though I still have a lot to learn I feel like I am 10 levels higher then I was. Having said that I watched probably all of the videos available on YT regarding different modelers. But there were none that gave me so much understanding on how different effects work, not only in isolation but also together and how they affect each other. You knowledge about sound and sound waves in just priceless. And seeing you being distracted by a drone flying "in f sharp" in one of the vides was one of the funniest things proving you really feel sounds around you.

@jakedemetrius_official8 ай бұрын

Can u just plug it into an amp?

@DaveBode8 ай бұрын

You could plug it into an amp and use the MX5 for compression, drive, and time-based effects. That has never been my cup of tea.

@jakedemetrius_official8 ай бұрын

@@DaveBode whats the difference between putting it in the cabinet or the amp?

@DaveBode8 ай бұрын

@@jakedemetrius_official The MX5 has a cabinet modeler block and an IR block. I think the best sounds come from using the built in amp modeling and going into an IR block. Then putting stereo delay and reverb after the IR block. That way you maintain the stereo imaging of the time effects. This video was showing the idea of not using amp models in the MX5 to get some diffrerent distorted/overdriven guitar sounds. That said, I usually always used an amp model for all of my patches.

@jakedemetrius_official8 ай бұрын

@@DaveBode so you can use it on an amp pedal board like a normal pedal? Whats an IR? I apologize I’m very new when it comes to gear.

@jakedemetrius_official8 ай бұрын

Long story short, I’m gigging around with my metal band with an evh amp and saw this online for sale and was interested. Do you think this would be helpful for me

@patpolowyk64349 ай бұрын

Great video, Im thinking of using my Isp theata preamp pedal with my Mx5 headrush.

@danielspangler835810 ай бұрын

I'm late to the party. Thank you for the video. Very informative.

@dariovaldivieso116110 ай бұрын

No hay videos con traducción...muchas gracias profe...q gran ayuda con este monstruo de pedal...gracias

@dariovaldivieso116110 ай бұрын

Grandioso..grandioso

@dariovaldivieso116110 ай бұрын

Profe cómo hizo el rig AMBIENT de la introducción....podría hacer un tutorial...felicitaciones gran trabajo..es un grande

@dariovaldivieso116110 ай бұрын

Gracias..super bien maestro

@rickkatevas622110 ай бұрын

You are very easy to understand, you explain things well. You would make a great teacher.

@Mythyyik10 ай бұрын

Один пиздеж

@Chinhoyi6210 ай бұрын

Sorry dude, but I can't take anyone seriously who has a guitar that looks like yours.

@DaveBode10 ай бұрын

That’s ok. My Solar is more comfortable, stable, and flexible than anything that Gibson, Gretch, or Fender produce. I haven’t needed to tune this guitar in 2 years with many hundreds of hours playing and ludicrous bends on every string. But not everyone like the look of innovation. Rock on!

@AngeloGuardia9 ай бұрын

hating Solar is a thing?... wow

@NJStew2210 ай бұрын

Dude thank you so much! I feel like I just learned so much about my MX5 and got an awesome preset out of this. I already started tweaking this to my liking and am very excited by the sounds I'm getting - Thank you for taking the time to become familiar with this pedal and for putting this video together!

@user-ex7yt9oh1f11 ай бұрын

Do you have a rig pack for sale with this shimmer rig in it?

@anglictina_by_danny11 ай бұрын

really fun. thanks!

@rcjarvis Жыл бұрын

great video man... great playing.. I love my mx-5 too... I never had a pedalboard since Boss ME-5... I will not sell any of my true bypass pedals but I do use the mx-5 live..

@johnhensley6808 Жыл бұрын

Just received my mx5, really appreciate your commentary and insights..most definitely agree with your question mark icon feedback, it would be a huge enhancement..really am happy and totally satisfied, with the options and capabilities it offers..not to mention, the education I fully expect to gain, through my own progress..your content certainly is enlightening, and highly encouraging..thanks much, glad to be aboard..

@DaveBode Жыл бұрын

Thanks! Enjoy the pedal!

@cakewalkgg Жыл бұрын

What an awesome tune. I hear some andy james, some paul wardingham, some rick graham. And you unique style. Flipping awesome man!

@marcelotactica Жыл бұрын

amazing !!!!! I love coldplay and you can open me a many sounds in mi mind for my creations. Thanks a lot

@alanpearson299 Жыл бұрын

I'm thinking of getting one,it sounds great my concern is getting rid of the amp and running direct into the pa?will it be loud enough to play gigs?

@DaveBode Жыл бұрын

If you are thinking of getting one, I have good news! I am selling mine with all my patches. It’s a great place to start because the stock patches are more or less useless. If you are interested, I’ll send you the listing. And yes, running direct is a great way to go. Lower stage volume makes everything sound better. As long as the PA is loud enough you are good to go. It’s never been a problem for me and all my patches need minimal EQ since I EQ almost all of them on studio monitors.

@alanpearson299 Жыл бұрын

Also,your video sounds 20 times better than the rest,why?is it through a better mic a cab or your software?

@DaveBode Жыл бұрын

Thanks. Nothing fancy with the sound. Just basic processing. The sound of the guitar is straight out of the pedal.

@alanpearson299 Жыл бұрын

Is he running through a pa or a cabinet

@liapin Жыл бұрын

Thanks for all of your videos, Dave! But would be great to get more examples with the Cali76 Stacked. Thanks in advance!

@bryanheck5091 Жыл бұрын

great video, but leave the tone knob of the rat alone, its literally one of the most classic dirt pedals, and that knob being reversed is a part of rock history.