Hey guys! My name is Zack and welcome to my KZread channel! Here I’m going to be showing you how to do certain things to your vehicle the best way I know how! Having a little fun along the way also!
Hopefully you find my content informative and entertaining! Don’t forget to subscribe and turn those notifications on so you don’t miss what I’ve gotten myself into this time!!!
Follow me on instagram!! I normally post teasers of future videos there first!!
instagram.com/z_p.tv/
Email: [email protected]
Пікірлер
After putting led turn signals my rear brake lights do not light up unless I’m using a turn signal. Do you have any suggestions??
Most likely a blown fuse. But it could be a bad brake light switch or a faulty flasher relay. I’d start at the fuse though.
Also make sure the leds aren’t in backwards most leds are polarity sensitive try pulling them out, flipping them 180 degrees and putting them back in.
I k is in a bit late but what’s the hight from the ground to the highest point on the truck, I’m wanting a 6” but I’m scared I won’t fit in my garage so the ol’ ladys saying I gotta get a 4” cause we have to be able to pull in our garage.
A technique I used was an angle bar drilled three holes. Two holes to accommodate the lug studs directly across from each other. Then rented a slide hammer and mounted the angle bar onto the shaft of slide hammer a secure the shaft with the supplied nut. Of course using the Blaster fluid helps. Then walling on the slide hammer got the whole assembly to pop out.
really wish chevy could bring back the cateye
Great job!
Get BG Syncroshift II with the additive, it helps with shifting.
I’ve heard of that through some of my research on the mt82! Ive also got a couple things on the way to hopefully keep some of the common issues from popping up!
😂
Classic black ice air filters 😂
They’re a must!!! 😂
I want to do the opposite swap. I hate how massive the NNBS handle is.
I personally like it but you could probably do it pretty easy!
Great work buddy! Wish u were near NC to set up my car audio. Keep the videos coming. 🐐
nice video.. as i can see you did not remove motor mount bracket, in most videos they are removing it and i dont get why.. if you could replace mount without removing bracket, so there is enough room for it )) i want to replace both mounts and gearbox mount as well on next week and your video gave me a hope not to remove bracket )) thx ;)
My thoughts exactly! Lol and happy to help!
The HD grille/hood has a wat mores aggressive look.
Does the remote start work, and the hatch on the new remote?
Yes!
Ok, so you know if it the newer remote will make the vehicle have remote start and open hatch if it wasn’t installed from the factory? My wife received a nice 2007 Tahoe from her aunt and I believe the keyfob she gave us is aftermarket (older simple one,) so I’m not sure what all options it had.
@@russelljordan2651 if it doesn’t come factory with those options they won’t work.. the lift gate is missing the entire motor assembly if it wasn’t a factory option and I think the remote start module isn’t installed as well if it wasn’t a factory option.
@@ZPTVChannel understand, I sincerely appreciate your help!
@@russelljordan2651 no problem!
Is there any way you can let me know where you got your grille I’m confused on the pieces in between the headlights
I got it off summitracing.com the painted side pieces just clip on!
How did you make your check engine, or any other warning lights perfectly blue? I tried this on my older silverado but with white led bulbs and it gives it this weird light green with light yellow since theres an amber film on the warning light, which makes it a weird color
I just put a blue led in there!
So I actually had a purple wire in the spot you used on the green fuse block. I followed this bundle of wire and found two unused plugs near where the fog lights go. Are you telling me they already had the harness ready to go for my fog lights?
Sounds like it! Some of them were pre wired but didn’t get the switch or actual lights. You should just be able to put the switch and lights in and it should work!
@@ZPTVChannel yes it was completely unexpected. Thank you for all your videos, I've watched most of them so far
@amplifythistake5498 I appreciate it!! Happy to help!
anyone know if this will this work for a 2002 silverado 2500 HD 6.0??
It should!
this is actually a nifty idea.
I put 2 bottles in my car, it doesn't work
It’s mainly for smaller leaks. If you put 2 bottles in it’s a pretty good leak lol.
Using a True dual battery isolator provides several advantages: Reliable Battery Management: Automatically ensures the starting battery is charged first, then charges the auxiliary battery, preventing the main battery from draining and ensuring reliable engine starts (True Battery Isolator). No Voltage Drop: Unlike traditional diode isolators, True isolators have no voltage drop, maintaining optimal charging efficiency (True Battery Isolator). Dual Sensing Technology: Monitors the voltage of both batteries and engages charging for both if either battery is receiving a charge, which is particularly useful when using external chargers (True Battery Isolator). Durable and Compact Design: Built to withstand harsh conditions with features like waterproofing, heat resistance, and anti-vibration casing, ensuring longevity and reliability in various environments (True Battery Isolator) (True Battery Isolator). Easy Installation: Simple three-wire installation without the need to bypass existing alternator wiring, making it user-friendly even for novice installers (True Battery Isolator). Cost-Effective Solution: Provides a budget-friendly way to manage dual battery setups effectively, offering long-term savings by extending battery life and preventing failures (True Battery Isolator). Safety Features: Includes ignition protection and operates within a wide temperature range, enhancing the safety of your vehicle’s electrical system (True Battery Isolator). Overall, the True dual battery isolator enhances the reliability, efficiency, and longevity of a dual battery system in various applications, from trucks to boats and RVs. For more details, visit the dfna.info website.
Did the transmission leak stop?
It eased it up but the leak is coming from a crack in the connection case between the trans and t-case so not much this could do lol
@@ZPTVChannel thanks man I’m about to add to mine was a bit skeptical because my homie had told me that ruined is transmission
@sparkysparkyboomman4578 his might have already been on the way out… there’s TONS of people including myself that swear by Lucas, it’s good stuff!
@sparkysparkyboomman4578 just make sure you don’t overfill it either. Overfilling will cause issues.
Thank you so much, excited to try this myself. Curious to know how the fix has held up after a year. Thanks in advance!
It was holding up great when I sold it! As far as I know it’s still doing fine for the new owner as well!
I just bought a used 2004 z71 1 owner and the 2nd day i had it on the road the brake pedal went mushy and i found a leak in my brake line bundle from the reservoir to the abs module where they are together in a plastic keeper on the frame. Evidently this is a common problem on these models. Its a damn shame that GM cut corners and used such cheep material brake lines on these models.
Right! Very common for these to rust out…
What’s the led strip called the link isn’t working?
amzn.to/3xdkvTD these are pretty much the same ones I used!
What LED lights are those? I have a 2000 Chevy Silverado 1500 LS. I want to change light bulbs to these ones that you got
amzn.to/3xdkvTD they are the ones I used!
@@ZPTVChannel so there not bulbs?
@yancyhammondjr no it’s a led strip!
@yancyhammondjr kept having bad luck with the bulbs so I figured I’d give this a shot and it’s awesome!
I know this video is almost a year old, but if you push the dash button with the road symbol on it, it'll clear that TPMS message
It only clears it for that drive… I wish the previous owner would’ve just put the sensors in lol
Was those door handle covers and side mirror covers?
Yes!
That Kenwood way better then that Walmart radio. Adjust the mounting brackets to make it flush.u ve installed for years. You have to adjust the mounting brackets on the radio
That hasn’t been my experience with them so far! This one is out performing the kenwood. And the kenwood was adjusted as far forward as possible. I sold and installed the kenwood in another Tahoe and had to dremmel out the inner ring on the dash kit to get it to sit flush.
If I’m not mistaken the remote wire will turn the amp on and off when you turn the key
They also make side mount bolt extenders for your positive and negative battery terminals for the truck 👍
@@frankswiader3334 I have those now! And yes that’s what your supposed to hook into but the red wire is a switched 12v as well same as the remote wire so mine still turns on and off with the radio!
@@frankswiader3334 I’ve just had bad luck in the past using the remote wire to where it wouldn’t power the amp at all so I just use the red wire lol
@@ZPTVChannel sounds good, thanks for your input 👍
Update...fixed it!!! All by myself!!! Thanks to your video!!! And it was only $27 for both!!! Thank you so much!!!
Happy to help!
Mine does not come back up when I start it. Going to try this!
For anyway struggling to seat the ball end in after getting the bushing into the rod end, make sure you're greasing the ball and inside the bushing. I could've saved myself 2 hours of work but just putting in a couple dabs of grease.
Thanks for this! Only question I have.. will this work for Yukon Tahoe suburban as well?
I think so but I’m not 100% sure
Dumb look, sounds good
That’s what I like about this kit! You can do the set up I have or have them come straight out the back!
Banks Power did research and has a better airbox than any warm air intake
Hi Gale
Sorry for your loss. Mustangs are a joke
Everyone’s got their opinion! I love it though!
Seems like somebody’s girl left him for a dude w a mustang lol.
Awesome video man! How have those new taillights been for the Silverado? I've thought about getting aftermarket ones similar to those for my 05 but have heard mixed things on the quality and how easy it is for them to get moisture inside the lights.
They’ve been great so far! They’ve been exposed to a few heavy rains and storms and they haven’t gotten any moisture in them!
Can i install these with some of the Owen's branded running boards?
If your inner rockers are still solid I would say it’s probably fine but these covers really don’t provide any support they just hide the rust.
How often do you change the fuel filter?
I want to say it’s supposed to be changed around like every 50,000 miles or so give or take a few miles. I normally try to change it as soon as I get whatever vehicle I have then kind of forget about it because 50,000 miles takes me a long time to get to lol
Those mirrors are wicked I got the snap on tow mirrors a few weeks ago unfortunately
That driver side header will burn through your steering boot if you don’t heat wrap it
I’ll keep an eye on it but it looks a good enough distance away it shouldn’t be a problem!
I have the same ones and they are great 👍
I love them so far! Have the plug wire covers coming in in the next couple days then I can actually drive it lol
gave me the motivation to fix my brake lines everyone else makes it seem like it's so super hard
It was more time consuming really. And the “hardest” one is the brake line going from the abs module to the rear axle just because it’s long as hell and kind of awkward to maneuver around things but other than that it’s really easy!
Hey bud, appreciate the video! Looking at the exact same brand right now, any long-term issues to report a couple years down the road now?
As of right now it’s still perfect!
@@ZPTVChannel Definitely appreciate the confirmation. Picked up a set the other day and threw it in this morning, loving it already! Thanks again.👍
Can you do this if you don't have fog Light. Or do you have to wire up to the fuse box an add a switch?
I have a video of adding fog lights! *INSTALLING* FACTORY fog lights on a 03-07(classic) silverado!!! kzread.info/dash/bejne/o6eupLObo8fLeNo.html
@ZPTVChannel ok I looked at mine and I have fog light plugs an no relay or switch can I just plug then In an add the rest
@ragnarlinn6431 yes! If you already have the plugs then yours is super simple! Just the switch and relay! I had to pin the fuse block and everything because mine didn’t come pre-wired…
@ZPTVChannel ok awesome thanks man
@@ragnarlinn6431 no problem!
sodering what does that mean exactly i want to do this mod the right way please repond
and where can i get the green harness wcould i just get a running light harness from the junkyard?
I can’t really explain soldering.. there are tons of videos on how to solder. Or you can use t-taps which is way easier. And yes you could cut the connector out of a junkyard just make sure it’s the blinker connector and not the drl connector.
Got one for father's day. Not this kit but, the set up works and went on w/o issue. The video's on line are definatley better than the printed 'instructions.'
Man thanks so much
I'm just wondering if everything is still working well cause i need to replace mine and don't want to disconnect ac Condenser. This looks so much easier than pulling radiator apart. Thanks for the information.
I sold it a while back but the guy I sold it to still has it the same way and as far as I know it’s still working perfect!
@ZPTVChannel thats good cause i just ordered one the same but different brand from Amazon. No way, i want to get AC regased so much better this way. thankz for the video .
@@judedavidson5453 right! And happy to help!
Thank u