Пікірлер

• 
  @jimbomorrison713310 сағат бұрын

  P😅

• 
  @jimbomorrison713310 сағат бұрын

  Thank you for your time. Bought a battery and found out my alternator was cracked on the bottom bolt,so I got a new alternator. Drove it around for a couple months,didn’t have anything to do so I watched your video. My battery,new,was low so I filled it,like you said,which I knew,with distilled water to the mark,so thanks and I will subscribe for that knowledge.👍

• 
  @TeW33zy12 сағат бұрын

  Wait a minute he only change 2 spark plugs on the other side?

• 
  @billbernhard358212 сағат бұрын

  When looking at this Walmart battery, it is clear that the unit is old and in need of replacement. Sulfating batteries like this one are 'kaput' !

• 
  @electrician-bn7gr14 сағат бұрын

  Snake oil

• 
  @NzubechukwuEzenwajikwa17 сағат бұрын

  Pls can you test it with car battery

• 
  @NzubechukwuEzenwajikwa17 сағат бұрын

  Pls can you test it with car battery

• 
  @Ez-lk2hl21 сағат бұрын

  Thank you my man! I been tryna fix my cobalt Exaihst problem for a while now since I have a heavier aftermarket Muffler/tip I’ve welded it about 4 times now!! This looks solid gonna try it and update.

• 
  @hobojo1022 сағат бұрын

  I like to hold my finger over one of the holes and fill it up with cleaner and shake it for a little while then let it drain out and maybe air dry it

• 
  @iosh4GКүн бұрын

  Casual Countach

• 
  @Bag514Күн бұрын

  Hey guys tell me , I put 2 quarts oil in after oil light came on and off , noticed after I had a huge puddle of oil , I noticed a leak underneath ,by the time I drove home 10 minutes , shut car off immediately, looked under car and seen small drips of oil ,checked oil and no oil , so my car was shut off but no oil in car , what should I do guys ? This is obviously a huge leak ,I won’t dare to even start the car with no oil of course, but do you think this would work ? help please guys

• 
  @greysonriegel465Күн бұрын

  Yeah mine still won’t come off 😅

• 
  @user-cs1ko6wr4qКүн бұрын

  How do I mount one of these on my Dodge Ram?

• 
  @h-waytwan1257Күн бұрын

  Well glad you made a review of it most people don't show the results at least you did.

• 
  @gregbgregb8487Күн бұрын

  It worked for me

• 
  @luisalexis44Күн бұрын

  Awesome. Thanks a lot. The only thing i don't see in the video is the advertise of the roller bearing in the gdi presure pump. It is inside the hole and when you take out the cover, the bearing suddenly get out and can cause serious damage to the engine if you don't see it fall inside. Not a big issue but good to know. Thanks a lot

• 
  @edhiggins2917Күн бұрын

  This Shit Works!! 166,000 miles on a 2011 GMC Terrain..That stalled. 15 seconds after starting.. White smoke..blew out for an hour after I put it in! This week 4th of July 2024. .Car purrs!. NOW? Had a backup Because SCOTTY the MAN!.. says just use a gallon of Lacquer Thinner..bought both..But Cataclean Worked! WHY PAY 3 grand?.. for a new Catalytic Converter..Just Clean it! If not perfect? Lights don't go out?. Try another bottle..THEN reset your cars electronics..HOW?. pull off the negative off your battery..Then put your lights on..Of course you wont see lights..But turn your lights on.THIS resets your cars Computer. Wait 5 minutes...Negative back on your battery. Good to Go!

• 
  @franciscogarcia7911Күн бұрын

  Ive seen multiple videos using this funnel, and some mechanics undo the temp sensor or bleeder valve on tstat. Is that required?

• 
  @froggystyle8781Күн бұрын

  Great Video, how do you tell if the thermo fuse is NO or NC?

• 
  @jayjb833Күн бұрын

  I’m scared

• 
  @dust_gale3108Күн бұрын

  Electrolyte leaking

• 
  @xierxuКүн бұрын

  I didn’t get any voltage at the harness

• 
  @CliffordChandler-gy4piКүн бұрын

  Thank you

• 
  @MrItsme2012Күн бұрын

  Thank you and great video! Im a subscriber now.

• 
  @PhillipsVisionКүн бұрын

  @@MrItsme2012 thanks for the comment and support 👍

• 
  @jayjb8332 күн бұрын

  How does this fix it

• 
  @ruckusallen2 күн бұрын

  much help Thanks!!!!!

• 
  @hemmosluiter5232 күн бұрын

  A drop of oil on top?

• 
  @bombadeer82312 күн бұрын

  Mechanical voltage regulators were replaced by zener diodes a long long time ago. By-1975 overcharging was solved 👍

• 
  @alvinrobinson69982 күн бұрын

  About how long did this take you to do all valve stem seals?

• 
  @PhillipsVisionКүн бұрын

  @@alvinrobinson6998 about an hour

• 
  @alvinrobinson69982 күн бұрын

  What are you standing on sir?

• 
  @allgoodtoday8292 күн бұрын

  Thats why i use a 6 point box wrench, cause the 12 point tend to strip

• 
  @bergatube602 күн бұрын

  Could it help cleaning the sensor?

• 
  @PhillipsVision2 күн бұрын

  @@bergatube60 I could if it’s failing due to dirt build up

• 
  @robertdavis57142 күн бұрын

  Deserves more likes.

• 
  @terryhill47322 күн бұрын

  Another way to check your alternator is hook up your multi meter to your battery and start engine and if it's charging the voltage will climb to around 14-15 volts if it's charging correctly if it decreases it's bad

• 
  @hatersgotohell6272 күн бұрын

  But what if battery is also bad. My battery says 11.5 volts 100% charge when off then when I turn car on it says 12.5 volts 57% charge.. how do I know if it's just battery that is bad or both battery and alternator in this case. ... I can't seem to reach my alternator with volt meter to Check it like this guy did.. any advice??

• 
  @terryhill47322 күн бұрын

  @@hatersgotohell627 You don't have to have your voltmeter on your alternator to check it like I said you hook to battery since it charges it and if your battery is holding 11.5 volts it should be alright with your voltmeter hooked to your battery while running it should show up to 13-15 volts and then turn your engine off and leave voltmeter hooked up and see if it holds a charge of 11-12 volts and both alternator and battery should be good 👍

• 
  @multisimple2 күн бұрын

  Kia RIO for the win

• 
  @gregbgregb84872 күн бұрын

  It worked for me. I used it about 2 hrs ago. It was a 2019 bmw 740i

• 
  @gregbgregb84873 күн бұрын

  It works just used it a hour ago. Right after I filled up the light was gone. I used in a 2019 bmw 740i. Glad didn't have to replace the catalytic converter

• 
  @ERock-x9p3 күн бұрын

  Is it me or did it look like shavings??? Not a good sign if that was metal debris….

• 
  @SammyNegrea3 күн бұрын

  to relief the pressure in the high pressure fuel pump, you need to remove the back seat and pry open the gas tank pump cover (which is glued) and disconnect two connectors, yes bullocks, then disconnect the front pump connector and run the car for about 20 seconds or until it stops itself. enjoy

• 
  @divergentmind20233 күн бұрын

  i was able to get only one lol i am going taking to the shop tomorrow and ask them not to do that again 😅 next day they almost could not take them off 🤣

• 
  @blackmatterlives98653 күн бұрын

  I borrowed my uncles. I try to twist it and when it got to 120 it became harder to turn. I needed 132 so I turn it a couple of more times, and it broke. I didn't know. Never used one. I guess he didn't exercise his. Now I have to replace it.

• 
  @antoniomarc71743 күн бұрын

  Cool

• 
  @TheKirkkeller3 күн бұрын

  thank you... for the guide...love the lock ... hate the design. whoever designed the system with the screw at the bottom, needs to rethink the design.

• 
  @jasiahromero33803 күн бұрын

  How to swap a idle air control valve?

• 
  @danielsee13 күн бұрын

  Remember the fuel pump is cooled by gasoline usually keep 1/4 tank for cooling.

• 
  @wreckim3 күн бұрын

  Badass, that's how my neighbor did it, when the AAA guy couldn't.

• 
  @noimis69293 күн бұрын

  Cleaning will work if the sensor is good, but fouled with carbon. If the sensor is bad no cleaning would work

• 
  @invader7773 күн бұрын

  Beats walking ha

• 
  @user-bx3dh1ng6f3 күн бұрын

  I agree with all four of these previous comments something made the fuses blow most likely going to happen again it's time to research the problem there fella

• 
  @cer22994 күн бұрын

  Thank you