Пікірлер

• 
  @MartinKBrown115 күн бұрын

  I've pulled the rear wheel back to out tension in the chain. But now the rear brake pads hit the tire instead of the tire's rim because the rim isn't flush into the slot. If i put the rim flush into the slot, then the chain is too loose. Any advice? Thanks.

• 
  @littlebigbikes130013 күн бұрын

  Hi Martin, if the pads are touching the tyre, you can slide them up the caliper using the 5mm nut on the back of each pad. You can see how to do this here. kzread.info/dash/bejne/fGiawdxwda7Rlrg.html

• 
  @MartinKBrown113 күн бұрын

  @@littlebigbikes1300 this helped. Thanks!

• 
  @littlebigbikes130013 күн бұрын

  @@MartinKBrown1 excellent, glad to hear that

• 
  @marcialmagdalena289429 күн бұрын

  Do the washers Go on inside

• 
  @littlebigbikes130027 күн бұрын

  Hi Marcial, when you are attaching the wheel, the washer goes outside the frame and the then the nut on top of the washer.

• 
  @jonrowlandson3759Ай бұрын

  Agree on the comments here. Although great that the bike can convert, it’s a major design floor that the jump in height of child required from no pedals to pedals is too great. So when the child is ready to convert (around 3 years old), the switched version of the bike is sized for a 4 or 5 year old. A shorter seat post is available that apparently remedies this, but you shouldn’t have to buy extra parts to fix a fundamental design floor in the bike’s unique selling point.

• 
  @DuncanSievwright2 ай бұрын

  What size are the two silver bolts that go into the pedal post? They were missing out my kit.

• 
  @littlebigbikes13002 ай бұрын

  Hi Duncan, they are a standard size M6 bolt and need a minimum thread length of 40mm. Please reach out to us on our email or whatsapp and we can get a set to you if they were missing from your kit.

• 
  @TrueWren5 ай бұрын

  This looks intriguing, what's the advantage of switching this round over just raising the saddle?

• 
  @littlebigbikes13005 ай бұрын

  Thanks. So by flipping the back of the bike, it makes the seat tube 10cm taller, and as the head and seat angle changes, the effective arm reach becomes 5cm longer. It also gives us the ground clearance to fit the pedals, which would not be possible if the frame was fixed. You can see the geometry of the bike here www.littlebigbikes.com/sizing-guide/

• 
  @serbaguna7828 Жыл бұрын

  Apakah cocok buat push bike merk lain kak?

• 
  @richielambe36742 жыл бұрын

  Ah lads can we have a detailed video on step 1 , everybody complaining on how bad the instructions are on this video.. I’m struggling big time , brutal video

• 
  @littlebigbikes13002 жыл бұрын

  Hi Richard, we're re-doing the website and videos at the moment and hope to have it updated soon. You can see how to loosen the cable here which will make it easier to release the cable from the cradle. kzread.info/dash/bejne/pmZ1w7OnqdWZkpc.html Otherwise please send me a video of your bike on whatsapp www.littlebigbikes.com/contact/ and I can assist further.

• 
  @kuridasd.i.y33162 жыл бұрын

  Can you put the link...where to buy that pedal kit?

• 
  @littlebigbikes13002 жыл бұрын

  You can see a link to the pedals here www.littlebigbikes.com/shop/littlebig-pedal-crank-attachment/

• 
  @kuridasd.i.y33162 жыл бұрын

  @@littlebigbikes1300 tnx

• 
  @iker94253 жыл бұрын

  Hi! I can’t go down enough with the seat bar. I would have been great to have a second smaller bar or a telescopic System with the pedals bar. Now I have to cut the bar. This bike is not suitable for all ages...

• 
  @littlebigbikes13003 жыл бұрын

  Hi There, many kids will have grown into the taller saddle height before being ready to progress to pedals. However if your little one is ready to pedal but still too small, you can purchase a short seatpost from our spare parts page. www.littlebigbikes.com/shop/spare-parts-for-littlebig-bike/ This allows the saddle to be lowered to 47cm while in pedal mode.

• 
  @iker94253 жыл бұрын

  Hi! There’s a problem because you can’t adjust the bar of the seat down enough. It would have been great to have a second shorter bar or a telescopic system with the pedals bar. Now I have to cut the bar. This bike is not suitable for al ages...

• 
  @FilmProz2 жыл бұрын

  You can buy a shorter 15cm bar from their website

• 
  @BrentDaughertyMe2 жыл бұрын

  Same. And too late to order another shorter post for this weekend.

• 
  @MP-mn2tu3 жыл бұрын

  Add commentary for goodness sake. Step 1 is a joke

• 
  @segunpalmer16293 жыл бұрын

  I am still struggling with step 1. It's difficult even after loosening the barrel.

• 
  @littlebigbikes13003 жыл бұрын

  Did you release the brake cable tension as shown in the link in the video description? This should provide enough cable slack to open the noodle quick release.

• 
  @segunpalmer16293 жыл бұрын

  I have tried that but I will give it a go again.

• 
  @segunpalmer16293 жыл бұрын

  @@littlebigbikes1300 I am still struggling with this.

• 
  @littlebigbikes13003 жыл бұрын

  ​@@segunpalmer1629 If you make sure the cables are not twisted around one another. The rear brake cable should come out of the left brake lever and directly into the hole in the frame. If they are twisted, remove the handlebars (like during the initial assembly), unravel the cables then re-fit the bars. Can you send me a photo of the brake lever adjustor to [email protected]. You can also whatsapp photos via the button on the home page.

• 
  @charinapaez55703 жыл бұрын

  Please revise your video to troubleshoot Step 1. This video was not made with the average parent in mind.

• 
  @littlebigbikes13003 жыл бұрын

  If the brake cable is too tight to open the quick release, the cable can be loosened as described here kzread.info/dash/bejne/ioJqldRwe9Cpdqw.html

• 
  @x11y22z33me3 жыл бұрын

  Step 1 seems hard. I can’t seem to get the brake noodle out. Any advice?

• 
  @littlebigbikes13003 жыл бұрын

  If you loosen the brake cable using the silver barrel adjustor at the brake lever. First rotate the larger locknut anticlockwise, then turn the smaller inner barrel clockwise. This will loosen the cable and allow the noodle to be freed. Once you have done the conversion, turn both adjustors back into their original position. Hope that helps but if not please send an email via our contact page.

• 
  @josephdougherty39603 жыл бұрын

  @@littlebigbikes1300 The first step is so difficult. Can you please post a video of loosening the brake cable. It's not working for me.

• 
  @chrismorris863 жыл бұрын

  Agreed. Step 1 is nowhere near as easy as this video suggests. Useless!

• 
  @Blushiez1233 жыл бұрын

  Agreed this part is super difficult!

• 
  @Blushiez1233 жыл бұрын

  @@josephdougherty3960 did you end up figuring it out?

• 
  @mkleng4 жыл бұрын

  Hi, is it available to buy now in the U.K.? I can’t seem to find it and my toddler is growing fast

• 
  @littlebigbikes13004 жыл бұрын

  We're sold out right now but you can pre-order on our website www.littlebigbikes.com/shop/

• 
  @Seramo14106 жыл бұрын

  Thanks for ur bike..below my 2 year is riding it.. kzread.info/dash/bejne/pn2EuctudL3MeNI.html

• 
  @sarahjanebarrett88706 жыл бұрын

  These bikes are amazing we have two one for our 4 year old and one for our 3 year old. They love them. After a while they were begging for us to put the pedals on and they were cycling in under 9 minutes amazing - they have a confidence that they never would have if they had traditional bikes with stabilisers.

• 
  @LukeMcDoop7 жыл бұрын

  Awesome!

• 
  @JaredHuet7 жыл бұрын

  Just got one of these for the lil lad for Christmas. Fantastic bike. Is it possible to put the pedals on, when frame is in the smallest position? Or should we rotate frame first?

• 
  @littlebigbikes13007 жыл бұрын

  Hi Jared, Glad you like the LittleBig. You have to rotate the frame in order to attach the pedals. They won't fit on the smaller mode. You can see how to do this in the instruction sheet provided with the bike. Thanks

• 
  @JaredHuet7 жыл бұрын

  Thanks Simon, he loves it, have some greats vids of him on it. The bike has worked a little too well. Our 3yr old is cycling with the pedals already. Is there any way we can get a shorter seat post for the saddle as it it a little high for his legs? We are based in Dun Laoghaire.

• 
  @littlebigbikes13007 жыл бұрын

  Hi Jared. That's great that he's taken to the pedals so quickly! We don't have any shorter seat-posts but if you trim the one you have to the desired length with a hacksaw, you can buy a replacement through our shop for when he's taller.

• 
  @littlebigbikes13009 жыл бұрын