TAT Express Inc is a diesel repair shop focusing on keeping semi trucks safe and running correctly. Located in Dallas, Texas, we plan to use our youtube channel to educate truck owners on how to keep their semi-truck maintenance and running safely on the road.
If you have any questions feel free to reach out to us at
[email protected]
Shop Info:
TAT Express Inc.
4140 Langdon Rd.
Dallas Tx, 75241
Call 972-225-3017 to schedule an appointment
Check out our careers page if you are interested in joining our team.
tatexpressinc.com/careers-page/
Check us out on Facebook
facebook.com/tatexpressinc
Пікірлер
You think that dd13 could fit in a 1 ton c30 dually?
My ddec 5 and 6 will out pull my DD16 all day long and use less fuel!
Geese not like you nocking off another youtuber...........
I seen olot off your video, anyhow most off break downs are (Cummins)
Lol I shud buy another truck then?
That’s why military f350’s come deleted from factory
Has any asked about oil into coolant? That is one video I would like see your diagnostic’s.
Excellent video and commentary ! Well produced .
I have a 2018 volvo vnm 200 and I had a guy hook up a car scan tool to it and now I'm not getting any communication from ecu. I'm in derate with no check engine light or faults. Runs and drives but 5mph only. What should I check to fix? Thanks in advance
❤
Should you inspect bearing on a high mileage truck?
Wouldn’t be too surprised if it had poor EGR delete job prior to that
Is the 1/4 inch where the angles stop on the shoes?
This guy must be sponsored by the EPA lol.
What's standard operating psi for the oil pressure? 50psi+ my dd15 gets. What's considered "low" or "abnormal"???
Pretrip
Q es la solucion??
Too tight or too loose?
That the cause of a clogged EGR system
Keep up the great work, get these driver back on the road and on top of the game.🚛💨💨
Stop the leak
No leak is a good leak
Looks good to me
Thank you I'm going to go get my overhead adjustment right now
Time for a rebuilt
Is this only for Cummins or can this be done with all engine manufacturers?
Mack mp8 engines as well the same concerns?
There is not a single success delete just delay of huge headaches and loss of money
I don't like these short vids with no explanation. If I knew what the hell I was doing I wouldn't have to watch videos.
This is a combustion gas test to confirm if gases are entering the coolant system. This unit was reported to have excessive coolant pressure but the first test could not confirm. In additional the unit had EGR valve faults and additional coolant leaks. After EGR repair, compressor coolant lines, and coolant tank, replacement the combustion gases were more contained and the test was able to confirm possible head gasket or head failure.
Thanks for that excellent explanation
Breakout harness
OTR ALL THE WAY
Bad injectors?
Paccar's best running MX13 straight off the assembly line
Hi. I got a 13 litre in a Mercedes actros (uk ) water going into oil . Any ideas?
There’s the green lol
Those German engineering designs just did not make it too good??ever since Mercedes took over Detroit
I’m think a lot of y’all need to get this checked. I hand out “lane lessons” all day long.
Didn’t change to green so there shouldn’t be any hydrocarbons passing through
I hav 2012 d13, almost 800 k miles without major problems, and I rarely idle. If driver has idling fetish and idles his truck every noght then you’ll have problems with after treatment
I still do the coke bottle
How much will he to change all brakes and drums on truck
Ok
Can you do a full video of this?