Пікірлер

• 
  @SUPERPHATBUBBALITEКүн бұрын

  Hay can you please put the part number for the scan tool you are using here because the Amazon like in the description is no good.

• 
  @hakeemshabazz2691Күн бұрын

  Pcv hose maybe

• 
  @hakeemshabazz2691Күн бұрын

  It’s the ground

• 
  @ismaeela2Күн бұрын

  Where is the mass air flow sensor?

• 
  @thomasspengler3506Күн бұрын

  great video,, very informative

• 
  @ChicagoRob2Күн бұрын

  What a great mechanic.

• 
  @DavidSpencer-b4sКүн бұрын

  Stool giveaway 1:01

• 
  @hakeemshabazz2691Күн бұрын

  Ground or wire from starter to ignition switch

• 
  @KyleStone-q5oКүн бұрын

  No help

• 
  @FranksShitBoxCollectionКүн бұрын

  I'm a mobile mechanic and want to add a key service so i wanted to ask if you recommend this tool ornif theres a different one that you recommend for beginners?

• 
  @CRAZY_VIDS07Күн бұрын

  Cool vids but may want to little more normal 😅sound like you reading a script 😅

• 
  @hakeemshabazz2691Күн бұрын

  You think vibration did it?

• 
  @tennaj1367Күн бұрын

  4:08 Good idea,. would be good also to tape the rod and leave the tip exposed.

• 
  @tennaj1367Күн бұрын

  Great work! Subbed

• 
  @pajtajКүн бұрын

  Very detailed and to the point video!

• 
  @NinjaBoy504Күн бұрын

  16:45 isn’t that the ONLY Honda smart key? Besides the 2023?

• 
  @RICKY-LSX2 күн бұрын

  How much did you charge for all this work with parts included

• 
  @robertsvcsmith96172 күн бұрын

  how did you get into this line of working?

• 
  @gixxerboyroyluvdrumswaters90232 күн бұрын

  Poor BMW got more problems than a little bit, someone told me they are beautiful when running but after a few good runs do not hesitate that nothings going to go wrong. Dude was right! 😢😮

• 
  @gixxerboyroyluvdrumswaters90232 күн бұрын

  This just happened to me in my 2011bmw328i coupe, belt is shredded some of it i got out, some is stuck in the fan. So its a possibility it went into the block or oil pan?

• 
  @TiresOnFire68792 күн бұрын

  Same truck, same issue. Found a dead rat in the cowl. Right in the "fresh" air intake. 😮

• 
  @johnrodgers18472 күн бұрын

  Nope, was looking at getting one of these explorers, not no more.

• 
  @jasnapon2 күн бұрын

  Great job bro 😎

• 
  @vintagetrk2 күн бұрын

  Cylinder 3 needs new coil.

• 
  @shanelady10493 күн бұрын

  I would like to add that if you suspect a bad coil then replace it asap because they can sometimes dead short and there's no protection for your PCM so it will fry your PCM then you are out thousands of dollars

• 
  @mikematthews2343 күн бұрын

  That damn fuse 23 was the problem for me 21 codes wrecking my brains Someone actually pulled the fuse and put it somewhere else smh crazy

• 
  @GuyDagenais-tc7li3 күн бұрын

  En frsncais

• 
  @tigerrely24173 күн бұрын

  I just bring my crv to dealer and they suggest to change the four sensors for 890$ thats too much so I declined the service.

• 
  @danielhamby94483 күн бұрын

  I’m going through the same thing except mine is mostly when turning right or left from a dead stop.. it’ll bog down then all of a sudden it’ll take off like crazy. Dealership said it was the tires because one was worn more than the other 3 and it was doing it because it was awd. It does it infinitely worse during winter and cold weather.. no brake light on though

• 
  @Jumbjetsky3 күн бұрын

  There is so many problems with that engine. Kia should be sued for this shit

• 
  @arsenyrazhkov45593 күн бұрын

  Could also be a broken valve spring. It would also make compression read zero

• 
  @Rejilesh99953 күн бұрын

  ❤

• 
  @gerardoespinoza72023 күн бұрын

  Great job! I have the same problem in my Silverado, I wish you can help me repair it, how much a repair like this cost? If you don’t mind me asking

• 
  @marcusLawrence-t9x3 күн бұрын

  my compressor is working and clutch is turning but my air is blowing hot but my expansion valve is cold but pass that my low side won't get cold

• 
  @Andys5v84 күн бұрын

  How do you tell if you have the convenience key feature? I have an 07 s5 without push start

• 
  @HOMBRESDECAMINO4 күн бұрын

  Thank you 🙏🔥🤝🫡

• 
  @HOMBRESDECAMINO4 күн бұрын

  Tenía 1 día completo chequeando un mini que compre en copart solo tarde viendo este video cambie el relay y ya prendio, Gracias mi pana por tu tiempo 🎉😅

• 
  @drakeautos10694 күн бұрын

  hi dont know if u still there have question about a 2010 canyon ...cranks but no start ....fuel pump new..have engine lite..engine run with starting fluid...otherwise not starting

• 
  @MrPapakuka4 күн бұрын

  kool

• 
  @MrRChitty4 күн бұрын

  Can I install the Diablo and delete the AFM without replacing/changing the parts in my engine? I don't have any damage.

• 
  @zxcdarel5 күн бұрын

  does this obd connector use fuse? if yes what is the logo in the fuse box?

• 
  @maxblay68335 күн бұрын

  I wish there would be a simpler video that would actually help me with my issue I don't understand wires

• 
  @nymphowolf5 күн бұрын

  I'm glad my 6.2 Escalade Esv is a 2007 the year or 2 before they activated the AFM system, i guess on my year it has the hardware but wasn't utilized till 2008 or 09. i currently just hit 180,xxx miles on her and do all my oil changes. i go by the computer life tho and once it falls to 20 to 25 percent oil life i change it. I use full synthetic Pennzoil oil and a Boss Purgalator oil filter.

• 
  @Info-Tech-5 күн бұрын

  So best teachers

• 
  @GSK-mc7rw5 күн бұрын

  Never heard anyone talk so much crap in all my life

• 
  @marklindquist24945 күн бұрын

  I.would have done.exactly what you did but that was a pickup you tilt the bed up on the driver side to access the top of the fuel tank for a fuel pump or whatever instead of dropping the fuel tank. It's easy and quick.

• 
  @christopherderavine5665 күн бұрын

  I rarely comment on videos but this definitely deserves a comment and a million likes no cap. I’m currently facing the EXACT same issues as the car in the video in my car and now I’m going to try to change the relay to see if my ac is going to work.

• 
  @freddyhollingsworth59455 күн бұрын

  05:55 I agree the AC condenser is the cause of the restriction, but I bet too many of the the micro channels are clogged with debris from the previous failing AC compressor... I really don't think that one dent in the bottom of the condenser can cause the whole condenser to "clog"? Great video!!!

• 
  @AfricanApples5 күн бұрын

  I'm looking at a Nitro 2010 that has misfires... but i don't hear anything good about this car !!!

• 
  @danielcamarillo49886 күн бұрын

  Hey man great video and loved the in depth explanation, one question maybe some one covered it somewhere in the comments but what is the reason to plugging the pressure relief valve in the oil pan