i’m young and trying to learn these mechanics and i stumbled across your videos i just binge watch these to learn all about motors and engines thanks for uploading these videos and don’t ever feel discouraged please keep them coming 💪🏼

Awesome rebuild! Your mechanical knowledge and skills are crazy for your age. Super impressive.

Nice work man like how you are cleaning up replacing all worn parts, The little details make a big difference!

Awesome build!!

Very good job and thank you for sharing it.

i love rebuild videos

Turned out great bro🤙 keep it up

Beautiful job buddy 🤙🏼

Love your vids man

I piut my thrust washer on, then the primary drive gear, then the second gear, and the second gear didnt make it all the way to the end of the shaft, making it impossible to get them tight. Also the primary drive gear dosent line up with the driven gear on the basket. It meshes about half way, actually less. And one more thing, there is a huge air leak through the splines on the crank, Anyone making sense out of all this? I even checked to make sure my year modle was a 2001. I did notice the repair manual that someone gave me was for a 2019 yz250. Was told they were the same . Cant find one for a 2001

At

Yamaha semakin didepan

You need to be trying to contact some top amateurs in the Texas area, they would easily hire you!!

I didn’t know you could press the bearings into place like that I thought they had to be frozen

👍👍

Great job rebuilding that motor but why wouldn’t install a new clutch? Those clutch plates you installed looked really burnt up

Do you have long-term experience with the hot rods crankshafts? I've read about connecting rod tears many times.

Hi I’m rebuilding a yz250, I replaced the bearings along with the bearing cap/seals and the crank as well. When I went to put the casing back together, it didn’t want to fully seet down. I ended up getting it about a quarter inch away from being fully flush but it won’t go the rest of the way down. When i tried putting a few screws in the block and lightly torquing them down to see if it would help, it caused the crank to freeze up and also made no difference in the gap in the block. Any ideas?

How much to rebuild my yz125

Wish we could seen the last pet put on the bike