Thank you. Happy riding✌

The cerakote is looking proper

@RecreationWerx

4 жыл бұрын

Thanks dude!

Putting together a 02' YZ125. With gear shafts, forks, and cam installed, I test fitted the other case half to test gears. It keeps getting locked on the dogs. Though the gear cycle. Do the gears on shafts 1&2 need to be timed or something. Wanna make sure before I install crank.

@RecreationWerx

3 жыл бұрын

Make sure you have everything lubricated and you spin the shafts while going through the gears

What is cerakote and how long did you bake the cases and at what temp? Thanks for the excellent video😀

@RecreationWerx

3 жыл бұрын

Cerakote is a coating company that specializes in durable thin coating that have high chemical and heat tolerance. You can check out their website! I pre heat the cases in the oven for 1 hour then apply coating. Then bake again for a full hour.

Also, did you coat the steel parts in any kind of light oil during re-assembly? Thx

@RecreationWerx

3 жыл бұрын

Yup use some mixing oil or transmission oil as assembly oil. I use both depending on the part

bro is pro x a good piston choice i found one on amazon with all the things needed for 74 dollars?

@RecreationWerx

3 жыл бұрын

Pro-x is great, OEM quality for a great price. Nothing but good experience on my end using prox

the cylindrical bearings at 2:57 you installed, were the stamped letters on the race facing up towards you or down into the case?

@RecreationWerx

3 жыл бұрын

Stamped letters are facing up towards me

@dr00andrew

3 жыл бұрын

@@RecreationWerx thanks for the response. i forgot to take a picture and the service manual doesnt give you that info. cool and both get installed letters facing up correct?

@RecreationWerx

3 жыл бұрын

@@dr00andrew correct, happy wrenching and happy riding!

@jtglenn3

2 жыл бұрын

Common sense

@dr00andrew

2 жыл бұрын

@@jtglenn3 no need to be an asshole

I see you hit the bearing in with the socket on the inner race? Is that a bad thing to do? I did that today and am worried it wrecked the bearing.

@RecreationWerx

3 жыл бұрын

As long as you are careful and use the right size socket you can feel the difference in the taps once the bearing is seated. I prefer to use a light weight brass hammer or a plastic hammer.

@fabyanjim1

2 жыл бұрын

Never and i repeat never hit the inner race to install a bearing. The correct way would to find something the same size as the outer race thats where u apply pressure hits etc.

What year is this YZ?

Wicked video, could use this a step by step. What oil do you to put in seals and/or bearings?

@RecreationWerx

3 жыл бұрын

Thanks dude! I’ll use what oil will be on that part when running so on the trans bearings and stuff I’ll use trans oil and on the main bearings/ seals and piston I’ll use my pre mix oil. Yamalube 2R

@georgesparrow100

3 жыл бұрын

Alex Tucker ahhh that makes sense, thanks!

What’s the year of this yz 125?

@RecreationWerx

3 жыл бұрын

2002

@Lowkey_Lee

3 жыл бұрын

@@RecreationWerx thank you