In this video I work on the Continuously Variable Transmission (CVT)
Жүктеу.....
Пікірлер: 8
@kronomarine3 жыл бұрын
I just picked up a 2008 Grizzly 80 from Key West Florida for 160 bucks... It's a total rust bucket. I was told that it had been flooded in salt water and the owner and mechanic couldn't get it started... I took it home and had it running in 10 minutes... I love tinkering with these things and obviously you do too. I’ve enjoyed watching your videos... Thanks for your help!
@spaguru4 жыл бұрын
You can use a piece of 2 inch PVC pipe on a press to compress the secondary pulley spring to remove the big nut... Use two belt cover bolts in the holes on the outside of the secondary to create a gap for the belt to sit in. The pulley sheaves will spread apart as you tighten the bolts in. Very handy tip for ya!
@spaguru4 жыл бұрын
Weigh all the rollers and make them the same weight, the drill a hole or two through the middle of them to lighten them up and the machine will rev a bit higher before the belt engagement. Moves the power and up higher in the revs. Do not grease the rollers! It just attracts grime...
@stevewatr
4 жыл бұрын
Cool tip. Thanks.
@superitachi43112 жыл бұрын
cant wait till part 15.
@sleblanc7412 жыл бұрын
me too!!!!
@jfedorek866 жыл бұрын
Is there a bearing in the cat co er. Mine bowls now
@stevewatr
6 жыл бұрын
Jesse Fedorek I'm not sure. I never did fix the noise issue, but it still works.
Пікірлер: 8
I just picked up a 2008 Grizzly 80 from Key West Florida for 160 bucks... It's a total rust bucket. I was told that it had been flooded in salt water and the owner and mechanic couldn't get it started... I took it home and had it running in 10 minutes... I love tinkering with these things and obviously you do too. I’ve enjoyed watching your videos... Thanks for your help!
You can use a piece of 2 inch PVC pipe on a press to compress the secondary pulley spring to remove the big nut... Use two belt cover bolts in the holes on the outside of the secondary to create a gap for the belt to sit in. The pulley sheaves will spread apart as you tighten the bolts in. Very handy tip for ya!
Weigh all the rollers and make them the same weight, the drill a hole or two through the middle of them to lighten them up and the machine will rev a bit higher before the belt engagement. Moves the power and up higher in the revs. Do not grease the rollers! It just attracts grime...
@stevewatr
4 жыл бұрын
Cool tip. Thanks.
cant wait till part 15.
me too!!!!
Is there a bearing in the cat co er. Mine bowls now
@stevewatr
6 жыл бұрын
Jesse Fedorek I'm not sure. I never did fix the noise issue, but it still works.