You’re better off fitting some tubes to the adaptors and plug them and leave them fitted for future use, this set up is fitted as standard to some of the Thunderaces and is far less fiddly to use with the carbs fitted.

@rapidstu01

Жыл бұрын

I have a set of tubes that came with my old vacuum gauges, they are easier to fit but do not have barbs like the ones I have used. I prefer the barbs so the plugs can't work loose. But it is an option I should have mentioned. Thanks for mentioning it 👍

@COBRAcz23

Жыл бұрын

@@rapidstu01 what adapters you buy ? I will have to again balance my carbs , last time when it was in garage i pay heavy price for works so i decide tu buy Vacuum Synchronizer and i have to buy those and leave them permanently , because this is really nightmare .

@rapidstu01

Жыл бұрын

@@COBRAcz23 I can't post a picture on here but the adapters are very cheap and on ebay. I believe they are called M6 brass vacuum adapters, or M5 vacuum adapters, depending on the thread on yours. If you look at my earlier videos I think I show them. I hope this helps

@COBRAcz23

Жыл бұрын

@@rapidstu01 i think i found them , well i will see if it is M6 or M5 i will have to clean carbs and balance them them after that so I put those in to the air intakes so next balance will be much easier .