Excellent explanation to how to do the job....Thank you from South Africa...

Excellent!! Very detailed - the best I've seen on this project.

@coachvonyo

3 ай бұрын

Thank you!

Thanks for the awesome video .

I’ve got a 2009 Grizzly 450 with around 4000 miles never touched the belt or clutches rode many trail miles hauled a lot of firewood never smoked the belt great cvt! Still running factory battery after 15 yrs ! Yamaha rocks ! Probably should check the belt at this time

@coachvonyo

3 ай бұрын

Oh yea, excellent belt system. The best. What I describe in the video is recommended preventive maintenance. You can get by with a lot more mileage though, especially on the ATVs.

I used Tink seal on both clutches 2000 miles ago. When I took them apart the secondary looks great. The primary however, most of the grease came out and was all over the cage. I think I going to an ultramatic equivalent on the primary and tink seal on the secondary.

@coachvonyo

Ай бұрын

Interesting and thanks for commenting. I'll keep an eye on my Rmax as it has tinkseal. I wonder if your primary o-ring got leaky? Not sure how else that would happen.

Amigo el embrague primario le servira a una cuatrimoto grizzly 350 el que se ve en tu video trae 4 tornillos y el de la mia trae solo 3 tornillos rn la tapa no encuentro el de ella pero son casi lo mismo

Great video! What’s the name of that other grease that works for both? Can’t get yamalube this weekend trying to find an alternative. I have brake caliper silicon lube, thought of trying that

@coachvonyo

4 ай бұрын

Tinkseal works for both. I know bel-ray wheel grease would work in a pinch for a short time if it was changed back out quickly. Really not sure about anything else.

@nathansmees1471

4 ай бұрын

@@coachvonyo cool thanks for the quick reply. I’ll see what’s available

@mc-rob4762

2 ай бұрын

@@coachvonyomarine grease works very well for all services on this clutch due to its waterproof properties

@coachvonyo

2 ай бұрын

@@mc-rob4762 I had a negative experience with a Grizzly 700 and a great waterproof grease (Belray) and never tried it again. I suspect it was a combination of extreme heat/cooling cycles with the motion and dust contamination over time from the cooling air pumped through but the grease broke down and the sliders were making an awful noise. I had to get back in there and service it within a year. I won't claim that one experience is the holy Bible though, I just never tried it again.

Who else is here after too much dirt and water got in their clutch from excessive mudding 😂

@coachvonyo

2 ай бұрын

Probably more than would like to admit!

@shootermcgavin1485

Ай бұрын

Me at the least, I fully submerged mine 🤦🏼‍♂️

@mc-rob4762

Ай бұрын

@@shootermcgavin1485 same, my back end was completely under water so I had to get off my quad in waist deep water and throttle it out. Thank god my exhaust tip is angled at 90 degrees otherwise I’d of been done for 😂

I remember watching you do that in your garage. ⚙️🛠️🪛

@coachvonyo

5 ай бұрын

Yes we knocked this out on your Grizzly 700 years ago.