I'll be tuning into this series over the next few weeks. I''m replacing the crank on my 02 Yamaha Warrior! Cheers!

excellent vid thanks for the knowledge

Seems to be very knowledgeable young man. Did a good job on his presentation

ahhh teardown videos... my favorite

Great video, one of my favorite motors.

hope i never have to do this to my bear, but if i do il use your videos. very good job man

Thanks for this video! Tero se skłodom w garażyku

hey was wondering what the required torque for the head bolts are ???

You talk about the clutch release around 5:53 in your video. When I removed my cover it fell out, therefore I could not get a good look at the position it was in prior to removing it. I was wondering exactly how it lined up when putting it back on. Thanks

The plastic chain guard on the left side of the cam, does it curve left or right???

hey have a 02 warrior 350 tearing down to replace rod would i have to take clutch side of motor apart or can i just take the flywheel side crankcase off?

hey man I'm doing this right now.....on my warrior....the oil transfer dowels are the only ones that get o rings from the case to the head right

My left hand crankcase broke, Can I split the case without removing all the gears from the right side, or does it has to be removed no matter what. Thanks

if i remove only the stator i must align ?

Is the big bear engine kind of like the warrior engine

I've got a 2004 Yamaha Bruin 350. I've seem manuals on line but not for the information I am looking for. I've got to check to see if the key has sheared and moved the timing marks on the flywheel. I have a recoil start rope on mine. I don't know if I can put a breaker bar or a screwdriver to hold the start teeth in place while removing the bolt that secures the cover???

what's the tool u use in 1:13?

is this teardown similar to all other atv im new at this and just want to know how can i learn more about atv motors in general

What year is the raptor

In order to take the electric starter motor out to replace the brushes do would you have to get a fly wheel puller and take it all apart like that? or can you simply slide it out from the other side?

@donrutter6765

6 жыл бұрын

Rob Hayden there is a rubber oring in the starter where it slides in the block, its tight. Take 2 starter bolts off and positive wire bolt and it comes off with a little tapping.

Do you think that a 400 big bear crank shaft will fit an work in a 350 wolverine? "I'm hearing it will" love the vid Thanx for sharing!

@bigbear3505

7 жыл бұрын

it should be fit .. the different is that is a cylinder are abit bigger that all

У меня YFM350FW Big Bear 350 сломало крышку картера . Где направляющая для стартера . А в продаже в России их нет . Сколько у вас они стоят ?

Or do you even need it?

is this an automatic transmission? I have a Yamaha bruin that I am rebuilding and its an automatic.

@brettsporseen1626

9 жыл бұрын

+Matthew Shaffer No its a manual 6 speed with reverse.

Is this the same engine as on raptor 350?

@godarwin1282

9 жыл бұрын

yes it is

Is this a two wheel drive or 4 wheel drive?

@DakotaE57

6 жыл бұрын

Shaenele Parrish 2

Crankshaft broke in mine also