Yamah XV250 stator cover removal.
Just a quick little video of my 1989 Yamaha Xv250 and how to remove the Stator cover. This video was made for someone who genuinely doesn't know what the hell they are doing just like me.
I hope this video was helpful ! :)
Пікірлер: 14
Thanks for this video. I believe I have an oil leak throught the gasket on this cover and this video really helps!!
I bought an 07 xv250 and now I'm having problems with it starting. Someone told me it could be the stator, but before I do all that, I'm going to be putting a new battery in it anyway. I don't know how old the current battery is so I was already planning on getting a new one. If that doesn't work and it is the stator, this video did help. Thank you
Exactly what i needed to know. Thank you!
Thank you this really was helpful!
Why is there a ground wire? Is it to connect the alternator body to the chassis to ground it? I don't see a ground wire going into my rectifier, only 3 wire from the 3 phases.
I have problems with removing the screws holding the stator and sensor.... Any suggestion??... Ob better, is it possible or I have to change all the carter?😢
Man, thank you. I'm Brazilian, and here, it's pretty difficult to find someone to make this kind of vídeo. I need to replace this litlle sensor, I'm not sure How do I make this replacement. Can u help me?
Why do you have to drain oil
Do you recall a clip holding the starter gear inside the block? My starter is bad and I’m wandering if I can just pull it and put a new one on without opening the block
@mickzulyevic9882
2 жыл бұрын
It's been a long time since I did that however I don't remember seeing that, I would assume you would be able to remove the starter without having to pull the side case off :)
Did the bolds came out easy? With a normal screwdriver or did you use a powertool?
@mickzulyevic9882
2 жыл бұрын
I always use a rubber mallet and hit the screwdriver while turning so I don't strip the bolt.
How did you get the new gasket back on without taking off the wires?
@mickzulyevic9882
Жыл бұрын
I believe you can unbolt the harness and run It through, it been a bit since I've owned this bike so I honestly do not remember, best of luck !