No video
XPR Plasma Cutting Bolt Hole With Taper Using 3DLT Bevel Head
Plasma cutting countersunk bolt holes with the Koike 3DLT bevel head and Mastergraph EX2 using X-Definition XPR300 by Hypertherm. Also available on the Versagraph Extreme, CNC cutting machine for larger plate formats.
Пікірлер: 21
Looks cleaner and sharper than laser
@rmkensington
6 ай бұрын
On thicker materials it always is
Cool but beyond my budget right now.
Like the cutting effect with using Oxygen or Air? what gas did your machine be use in XPR300?
@KoikeAronsonRansome
4 жыл бұрын
They used Oxygen and Air as this is mild steel
@jackzhang7232
4 жыл бұрын
@@KoikeAronsonRansome for your beveling, you use Hypertherm system or your own system? And beveling device of Lifting up and down---Hypertherm or your own developing and researching ? Thanks!
What cut chart do you use to obtain required bevel cuts please?
how good is the quality when cutting stainless steel?
Impressive...
Wonderful tech
Plasma cutting dance club remix.
GREAT
What gases were used for the bevels? Is it possible to cut the holes with the bevelled side to the bottom? Carbide overlay plate requires cutting with the carbide down and the large end of the bevel must be on the carbide side.
@shanedunne7210
10 ай бұрын
I always cut carbide with carbide facing upwards
@chrisc188
10 ай бұрын
@@shanedunne7210 You're contaminating the base plate by doing so. Any welding done on the base will require a grind prep to remove contamination before applying a weld.
Donde puedo conseguir esa maquina ?
@KoikeAronsonRansome
Жыл бұрын
www.koike.com/mastergraph-ex2
How much minimum diamter (with bevel) koike can cut ? Can the 3D bevel head cut 31 mm diameter (with bevel) ?
@KoikeAronsonRansome
7 жыл бұрын
The minimum inner diameter is 16mm and outer diameter is 25mm with a 40 degree bevel.