Bro. What the heck happened with this problem. I have the same issue. Went trough the same steps. Still jumps around during the spin mode.

Hopefully you get it fixed

bearing job not done correctly. bottom bearing not in all the way. did you use the bearing tool from whirlpool? The rods you used were not oem as well but some cheap alternative. garden hoses dont fix bad suspension!

@falk0069

2 жыл бұрын

Thanks for watching and comment. I ended up replacing the bearing and shaft again and it made no difference. I then went back to my original suspension rods (tossing the cheap alternatives) and everything was good again. The darn cheap suspension rods caused me so much pain. I made this video specifically about the rods and how bad they were: kzread.info/dash/bejne/goVrmZecqK-alc4.html

Bad suspension rods!!!!

@falk0069

3 жыл бұрын

Thank you! You are absolutely right. My *new* rods were bad. I show the difference in my final video: kzread.info/dash/bejne/goVrmZecqK-alc4.html

I would buy the rods directly from maytag or whirlpool, buying them off of Amazon is just a horrible idea because, they can get damaged during shipping and if is just bad news, so I would recommend buying them from Whirlpool directly.

@falk0069

Жыл бұрын

Definitely the best, but the most expensive too. In my case the form material used on my replacement rods was garbage. You never know what you're going to get unless go with the manufacturer.

@kcook124

11 ай бұрын

​@falk0069 7 months late lol. But what kind of material was uses on the brand new ones