Do the same rules apply with a thermal clip on?

@LicentiaArmsCo

2 жыл бұрын

Absolutely ! All the same principles apply.

‘ZCO’s…NEVER even heard of them before. HAVE to check them out. GOOD starter vid..NEW to the channel..

what sr 25 is that on the right? Looks like an ecc with an urx3?

Is there - if any - risk to the clip-on from the heat from a can from a decent amount of sustained fire?

@LicentiaArmsCo

2 жыл бұрын

Not really with a setup like this. You wouldn't be firing at the rate of fire with the round counts necessary to really do any damage.

@CheckingStuffOut

2 жыл бұрын

@@LicentiaArmsCo brother, you must not have seem the hordes of hogs I have then (just kidding, thanks for the response).

What is minimum amount of rail space needed for a CNVD-LR? Trying to see if it would fit on a 10.5in (9in rail) w/ Atacr

@LicentiaArmsCo

2 жыл бұрын

It really depends on optic placement. If you wanted to go that short, we would recommend a cnvd over a cnvd-lr

@2keylows

2 жыл бұрын

@@LicentiaArmsCo Understood. Would you happen to know distance in inches from the rubber eyelet to the end of the larue mount? No worries if not. Appreciate your guy's content.

primer + case + gun powder + projectile = Modern day cartridge using Sammi spec guidelines for safety 1000lbs = 7000.00108027 grains What was the exact amount in lbs or whatever unit of measurement did the founding fathers stated to have ready just in case? How many Modern day cartridges could be made using the equation listed above using the appropriate materials for a modern day cartridge?