WEBINAR: Response Spectra Analysis using ETABS
Ғылым және технология
This webinar will demonstrate how to use ETABS to perform dynamic analysis. Examples for Response Spectrum definition, analysis and output for seismic design will be discussed.
This is a recording of the webinar that took place on Thursday, July 18, 2019
Пікірлер: 14
Csi should review and check these webinars for accuracy of information presented before posting them online.
thank you.
What inputs do you add for the "Loads applied" for a Ritz analysis?
what about the mass source!!
Thanks for the video.. Can u plz upload a video on the equipment loads on slab accounting the vibrations and its analysis???
What if I didn’t define any modal cases but in the load pattern, I specified and define the seismic lateral with all their parameters (codes, PGA, spectrum type, etc) for X direction and Y direction and choose automatic combinations. Won’t the program perform the seismic analysis???
how to use the excitation angle?
👍🏻
hi, why is scaling not done?
How to check excitation angle of building
@faisalzamankhan4657
3 жыл бұрын
First find out base shear in both direction x and y then excitation angle = tan-1(Fy/Fx)
Can etabs automatically do structural analysis and gives the quantity of materials?
@junio5456
4 жыл бұрын
nop
@yiannifunataoldotcom
4 жыл бұрын
Jigar rana yes of course