Want Micro Crimps?.... Try this DIY Build!
Hey everyone my friends at frictitious climbing sent me a set of their micro crimp holds. These are quality holds for sure but I dont know where I am going to put them. And screwing and unscrewing sounds like a pain so maybe I can come up with something a little more Modular... Let me know what you think. if your in the market I'll leave a link to firctitious below let them know i sent ya!
Stay sendy
Frictitious (not an affiliate) :
frictitiouscli...
My Merch Store!
betaclimbers.com/
You can buy me a coffee here:
www.paypal.com...
Here is a Discord link, come join the fun!
/ discord
You can click this link to see more of my videos!
/ betaclimbers
My amazon store where I put products I talk about in my videos. (affiliate link)
www.amazon.com...
Instagram - BetaClimber
Пікірлер: 21
Power tools are aid.
@BetaClimbers
2 жыл бұрын
🤣
@Jokl92
2 жыл бұрын
Tommy Caldwell would like to talk to you!
Really rad setup! Stoked to have you training on them. If the edges are ripping your fingers up you can sand the edges down to make them comfier!
@BetaClimbers
2 жыл бұрын
Thanks again! They are very comfy but my home gyms holds are not 🤣 currently healing from some hard sessions. 🤙🏻
I think these came out pretty nice let me know what you think. 🤙🏻
@mitchellbarnow1709
2 жыл бұрын
I think think that they are for pretty advanced climbers.
@BetaClimbers
2 жыл бұрын
@@mitchellbarnow1709 yeah that’s a good point I’d say if your intermediate go with 10mm first.
@mitchellbarnow1709
2 жыл бұрын
@@BetaClimbers Thanks for the great advice!
I need to get an inside training wall, that looks dope
You managed to talk about table saws and push sticks without mentioning Tommy Caldwell's missing finger. That story still makes me wince!
Sweet set up! Those micros look great!
As much as I don' like youtube power tool safety comments.... Cutting pieces that are short and thin and leaving them between the blade and fence can end up with one being launched back at you if it catches the back side of the blade. Use a spacer block against the fence but behind the front of the blade so you end up with an extra few inches between the cut off piece and the fence. Nice concept overall for quick change training holds.
@BetaClimbers
2 жыл бұрын
Always a big fear of mine. I want to build some jigs for cross cuts and stuff. Thanks for the safety tip much appreciated!
@alexnone5720
2 жыл бұрын
@@BetaClimbers No need to go full cross cut sled unless you have more projects. The cheap miter bar the saw comes with will do most work, just don't use the miter bar AND the fence at the same time with short pieces. Either pulling the fence off or sliding it a few inches out of the way will do the trick. For mostly repeatable miter bar cuts you can mark the table top with a pencil line.
Very good way to get any position possible. After watching this I feel like I should get good hard wood and take my wood router to create my crimp holes, i could create whatever I want.
smart smart Great video
Josh! Great stuff as always 🙂
@BetaClimbers
Жыл бұрын
Thanks buddy!
This is so smart
Yo sick Dovetail design