VW T4 Inner and Outer Track Rod End (no special tools)
No special tools! Replacing the inner track rod end on a Volkswagen Transporter T4 SWB 1.9 TDi
In the video I measure the length of the old rod. I check this again before I screw in the new one, but I forgot to film this. It is a double check as well as counting the number of turns.
I hope this video helps you out.
If you found this video helpful you might like to:
Donate: paypal.me/bootsowen
Support: / bootsowen
www.amazon.co.uk/shop/bootsowen
You can buy tools and parts, or things you were going to buy anyway from Amazon through the affiliate program (links below) and I may receive a commission for the sale. :
Disk Brakes (check model and fit!!): amzn.to/2RDnQTo
Pads (check model and fit!!): amzn.to/35HlGul
Brake caliper rewind tool: amzn.to/3hKngxH
VW T4 pressure sensor switch: amzn.to/2H3Evxq
vw track rod end t4 (check model and fit!!): amzn.to/3kszbCk
VW T4 anti roll bushes:amzn.to/32D3mQX
timing belt locking tool kit from Amazon through the affiliate program: amzn.to/3brAtKw
VW T4 Lower Ball Joint: amzn.to/2FGFgfF
or a multimeter : amzn.to/357iwj7
Or the timing belt: make sure you buy the correct one for your engine! : amzn.to/2DC5oHC
or you can buy anything else through the link. This has no effect on the price for you. The links used are affiliate links. As an Amazon Associate I earn from qualifying purchases.
Пікірлер: 10
im doing this job on both sides tomorrow morning on a polo....this video was a great boost to my confidence 👌. thank you
@bootsowen
3 жыл бұрын
Good stuff, worth a try, take your time. \Let me know how you go!
Awesome vid cheers now to find a 32mm spanner
Video bazı açılardan karanlık olmasa harika elinize sağlık başarılar 👍🤝
THanks for the video, I need to do my track rod ends so this helps. Thanks to Sandra for camera work and sound , what about multi tasking as a lighting technician too ? HeHe!!
@bootsowen
9 жыл бұрын
WildPhotoShooter Make sure to keep the tracking the same by counting the number of turns out of the old rod end, and do the same number of turns with the new one, provided that is that they are the same length. Have fun doing it , it is not a big job, best to start earlier in the day though! Thanks for watching!!
Only count turns IF new end identical in length, if not then measure. Hey, I thought this was no special tools needed, that was a joint splitter wasn't it....? I've just released my taper by hitting the side (as seen on many other vids) with a lump hammer, you don't need a splitter, a hammer properly used will free a taper.
@christophernunn943
Жыл бұрын
And maybe a little bit of heat too
Hey boots did you do tracking after this one or measurements suffice? Cheers
@bootsowen
9 ай бұрын
never did tracking on that van. same turns off as on. worked for me, if it was wrong before it will be wrong after.