If you haven't already please subscribe to our channel here kzread.info We have lots of new content coming soon!

Got a t5 swb with a rock and roll bed in back and captains chairs up front it has the kitchen build in too . Is there a way you guys can get a pair of removable chairs behind the captains seats so we make it a 6 seater ?I’ve used the previous front row twin seat just placed and there is enough room for a pair of seats between the fridge and the sliding door

Hi you can suplay and fit the seats and brackets

Hi, can you tell me what brackets are required for the third row of seats install please ? Thank you Ted

Hi nice job! Do you have the OE numbers for all the brackets you need for 2+1 installation? Thanks! Nice video!

@VanCreations

Жыл бұрын

Hi, I’ll look them up for you tomorrow! 👍🏼

@VanCreations

Жыл бұрын

4 x 7H0803547A small bracket 4 x 7H0803548A small bracket 4 x 7H0802763A large bracket

@k.w.lwildlifephotography9091

Жыл бұрын

Whats the cost for doing this?

Hi there, great video. What size threaded bar did you use to drop the tank please? Thanks

@VanCreations

9 ай бұрын

Hi John, I’m not in the shop today but I’m sure it’s 8mm threaded bar. I cut them to around 450mm length to allow us to drop the tank and leave it in position whilst we install brackets, diesel heating and other mods! Saves us having to remove completely and free’s up our gearbox jack. Simon

@VanCreations

9 ай бұрын

Hi John, I’ve just been in the workshop and measured today, it’s M8 bar. I’ve updated my other response.

@johnbungywilliams109

8 ай бұрын

Thanks

Hi, great video. Would you tell me what size pop rivets you use please?

@VanCreations

Жыл бұрын

Hi, 4.8mm x 14mm rivets are perfect! I hope this helps, please remember to like and subscribe so we can film more content! Cheers, Simon

@stevencadman4763

4 ай бұрын

Hi Simon, I agree, great video and thanks for sharing the videos and information you do. Are the rivets you use aluminium or galvanised steel?

Gonna install rear 3 seat bench on my t6 so just four quick release brackets. How sidficult is this and what support brackets do i need? Many thanks

@VanCreations

Жыл бұрын

It’s actually slightly harder to install the bench, mainly because you will still need to drop the tank but also the heat shield above the exhaust for the RH brackets. This means a bit more work disconnecting the handbrake and exhaust system before dropping the heat shield!

Just a question do you put any waterproofing etc around the brackets???

@VanCreations

2 ай бұрын

No we don't. Same as the VW factory built Kombi's. We do treat any bare metal from drilling with primer/sealer. You could put a bit of sealant around the holes prior to the brackets going in but we've never seen any water ingress from this area in retro fitted or factory Kombi's.

Could you do a video of the seatbelt install please ?

@VanCreations

Жыл бұрын

Thanks for the suggestion, I’ll make sure we film this on the next one! 👍🏼

@lucyfenney6090

Жыл бұрын

I need the seat belt instal video for this week - any chance?

@lucyfenney6090

Жыл бұрын

Ive just found very quick snippet from another video that shows it - let me know if you still need it and ill try and get it to you

Hi would it be possible to have the seats the opposite way around ? So the single is behind the driver and the double bench seat is next to the side loading door? Thanks in advance James

@VanCreations

6 ай бұрын

Hi James, You wouldn't be able to have UK seating the other way round as the seat belt receptacle and levers on the single seat would be on the wrong side and the seat is offset so I can't see that working. Also the belt and receptacle on the double would also be wrong. Best Regards Simon

@jamespemberton7762

6 ай бұрын

What about 3 single seats ? Is that an option? Thanks

Could you tell me the torque of the bracket nut tightening?

@VanCreations

Жыл бұрын

Hi, 55nm for the nuts on the floor bracket.

@MrSimixx

Жыл бұрын

@@VanCreations thanks!

Hi would you install some in my van?

@VanCreations

Жыл бұрын

Hi David, we can install any combination of Kombi brackets in VW T5 or T6’s! It’s one of the services we offer. We can install brackets for 2+1 seating, triple bench seat or triple single seat setup! We are based in Dorchester, Dorset! If you require any assistance or pricing please email us at campers@vancreations.co.uk

Great video, thank you, but..... why the dreadful music?

@VanCreations

9 ай бұрын

Sorry, but boring without background music and we have to be careful as to what we use due to copyright! Thanks for the feedback! Simon