Volvo V70 / XC70 / S60 Front Sway Bar Upgrade

How to replace front sway bar on a P2 Volvo. Time required, likely about 90 - 120min.

Пікірлер: 38

  • @willmill409
    @willmill4092 жыл бұрын

    If anyone does this make sure to replace the lower engine mounts. Might as well do them while your under there

  • @supersabrosinho
    @supersabrosinho Жыл бұрын

    Thanks for uploading. Lots of good info here, I've worked on Hondas all my life, now learning how to fix other brands

  • @raiderman28
    @raiderman28

    alot more work when you have to be moving the camera. i feel your pain. when i do videos, it gets frustrating. but you want to make sure your getting the shot. alot of work to drop that sub frame.

  • @raduvladimirmihalache9226
    @raduvladimirmihalache92263 жыл бұрын

    Good job! Thanks for the video. I am diving into the same procedure right now...

  • @carloscedronvalles6417
    @carloscedronvalles6417

    Thanks!!!! This video will be very helpful for me, I have to remove the anti roll bar in a XC70, I'll try to follow your steps. Thank you very much.

  • @reallyhappenings5597
    @reallyhappenings55974 жыл бұрын

    I know from experience what a hard job that is. So cramped along the back of that subframe.

  • @Biglink0
    @Biglink03 жыл бұрын

    Thank you very much, great help !

  • @user-cp4jc5my9n
    @user-cp4jc5my9n

    Very good Job. Next time i do the same at my V70R-AWD. Regards from 🇦🇹.

  • @torsteinengevik3744
    @torsteinengevik3744 Жыл бұрын

    This was useful!! I have purchased the parts but couldnˋt figure out how to get access to the bolts. -Wondered if I really had to loosen the frame under the engine. Now I know...

  • @sopdadope
    @sopdadope4 жыл бұрын

    Nice work, I struggled with the same job so I know your pain.

  • @familyrcvideosds3680
    @familyrcvideosds36803 жыл бұрын

    Did you replace the subframe bolts those are torque to yield ?

  • @JoeSibCars
    @JoeSibCars Жыл бұрын

    Hi I've started upgrading my sway bar my V70 is right hand drive but I had a crash shield around the Steering rack But what's the torque specs of the 4 sway bar bolts Thanks in advance

  • @nyc1dxo537
    @nyc1dxo5373 жыл бұрын

    Nice video and effort to film it. After all that work was it worth it? Any particular reason why you did it?

  • @willmill409
    @willmill4092 жыл бұрын

    How did your oil pan hold up? I wanna do this job so bad but I'm so afraid of cracking my oil pan by holding it up with Jack lol. I think it would be OK but so many people have told me never support engine with jack under oil pan lo l

  • @JnJShiffler
    @JnJShiffler3 жыл бұрын

    HELP. 2004 XC70 Front impact sensors. * Please tell me the location. * This car is making an ass out of me. Want to test to see if it latches closed or resets to open after a dash airbag went off. Sending out SRS Module to get reset. Doesn't seem to have wiring to detect if airbag is bad or impact sensor is bad. NOt positive though. But where the hell are they located? I have bumper and grill off and removed front right headlight. Following all cables, cannot find impact sensor. Wonder what color the connector is. HELP

  • @davesmith517
    @davesmith5172 жыл бұрын

    This is absolutely ridiculous for 2 sway bar bushings to be replaced….