Volvo Bulb Failure Position Lamp
Автокөліктер мен көлік құралдары
Volvo Bulb Failure Position Lamp is indicating a Marker Light is out but not all of the lights illuminate at the same time. some go out when the engine is running, The Back Lights come on when the trunk is open, etc, so finding the burnt out bulb can be difficult.
Пікірлер: 21
Pulling that lower, tough to reach tab away from the socket, while pulling the socket with a spring hook like you showed, was the only thing that seemed to work for me. Thanks for the spring hook idea. What a pain!
Wow, this was a bit hard to figure out how to remove that bulb but thank you! Whew! They also have them in LED but an electrician once told me unless you change all your lights to LED, you might start experiencing issues, so I'll wait off. I bought the regular bulb. Thank you for this video!
Serious skills to get this bulb out
Thanks for the tutorial. I have to do the same on my XC70.
@A_Renaissance_Man
7 жыл бұрын
Thank you for your comment. I hope all goes well.
You can take the whole assembly out by pulling the 2 rods at the end of the assembly, then its much easier to change the bulbs
Hello, I have 2012 and when I reinstalled the position lamp bulb the holder broke. Didn't force it simply slipped it in and it fell apart! Do you know if THAT piece can be replaced without buying the entire headlamp component?
@A_Renaissance_Man
Жыл бұрын
Whether you need the wired end that holds the bulb or the whole headlamp that the bulb goes into, I recommend calling L&B Auto and see how much it is to have them send you a used one. They are the largest Volvo scrap yard in the U.S. Look them up on line and ask for Justin. Phone not email.
Remember when these cars go down the assembly line they all get brand new bulbs (made on an assembly line as well) The cycle time on the light bulbs is the same for the bulbs They will work and they will fail at the same time. I have seen this with headlights and brake lights. For both bulbs to fail at the same time is common. They use the same wire so they burn out at the same time. Just remember this when both bulbs fail.
what was the bulb number you used?
@A_Renaissance_Man
7 жыл бұрын
Joe Williams 2825 was the bulb number I needed to use. Do not use 194 because that has a different voltage and wattage rating.
Both of my side markers were out and only 1 strip light was out aswell.. Very wierd
What is the diagnostic tool you use here?
@A_Renaissance_Man
4 жыл бұрын
Just a cheap iCarsoft i906
@pgreenx
2 жыл бұрын
my car had a message in the dash....
THx -= getting this bulb out is a royal PITA...
@GQuick-pj2md
6 жыл бұрын
marty xray understatement such bullshit i still cant get mine
Some segments in the video are stamped not adjacent to each other
Why do they make it so difficult
@A_Renaissance_Man
Жыл бұрын
Technically they use VIDA DICE but this is a non scanner DIY method.
C