I love your nice robot with your god tier driving skills! we got paired with you guys in a local event and won, remember??? :)

@7163BChewbotcaRobotics

8 ай бұрын

Of course! That was a great finals match, great job. Will you be at the tournament next week?

@CaliforniaPizza95133E

8 ай бұрын

Are you referring to the dublin tournament? If so, yes, but we aren't planning to go back to a davis tournament anytime soon because its too far@@7163BChewbotcaRobotics

@7163BChewbotcaRobotics

8 ай бұрын

Oh. I was talking about the Davis tournament, but good luck in Dublin!

Are you guys using a rubber band backwall? If so, do you have any tips on how I can make one without the rubber bands snapping my beams? Thanks!

@7163BChewbotcaRobotics

7 ай бұрын

Yes, we do use a rubber band wall. Try to add support beams and standoffs.

Great robot, didn't I already have a 132 teamwork match lol

@7163BChewbotcaRobotics

8 ай бұрын

your too good! :)

what piece do you guys use for the switch (the piece that moves when the bar hits it going into the supply zone) and also do you guys have your wheel axles on middle holes or on bottom or top holes

@7163BChewbotcaRobotics

8 ай бұрын

we placed our wheels in the bottom holes. we use 3 by 2 by 3 angle pieces for the phase-through mechanism

@user-sg9dj4fd1y

8 ай бұрын

@@7163BChewbotcaRobotics thanks but also do you guys use rubberbands for your phase or no rubberband

@user-sg9dj4fd1y

8 ай бұрын

and also how did you guys make it so smooth like even with the weight of the robot

How hard is it to build phase with a lot of weight on top? And are you able to show how yours works or a basic on how they work?

@7163BChewbotcaRobotics

8 ай бұрын

Building a phase mechanism requires a lot of work to make it smooth. Our mechanism is still evolving and maybe we will reveal it in a future video.

@SyntaxERRORRobotics

8 ай бұрын

@@7163BChewbotcaRobotics Ok, thanks!

Can you respond to this what is the gear ratio you would recommend

@7163BChewbotcaRobotics

7 ай бұрын

I would recommend 3:1

Do you have any recommendations for making a faster intake? Thanks

@pradyumnaaiyangar1024

7 ай бұрын

use a 3 to 1 gear ratio and set the code velocity to 1750 rpm. If you build it correctly, your motors will not be destroyed. Also, try to have the motors in front of the intake like theirs. If you think that I am not a valid source, my team is 18th in the world.

@7163BChewbotcaRobotics

7 ай бұрын

@@pradyumnaaiyangar1024 How does that work? I thought motors could only go 120 rpm's

@BonSoloYT

7 ай бұрын

Thanks I’ll try that

@pradyumnaaiyangar1024

7 ай бұрын

@@7163BChewbotcaRoboticsyou can set the velocity higher